𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Hydrostatic extrusion of polyethylene filled with hydroxyapatite

✍ Scribed by N. Hugo Ladizesky; Ian M. Ward; William Bonfield

Publisher
John Wiley and Sons
Year
1997
Tongue
English
Weight
109 KB
Volume
8
Category
Article
ISSN
1042-7147

No coin nor oath required. For personal study only.

✦ Synopsis

The hydrostatic extrusion of polyethylene filled with hydroxyapatite has been studied. It is shown that the extrusion behavior is qualitatively similar to that of unfilled polymer. Extruded products with flexural moduli of at least 10 GPa and flexural strengths of 90 MPa have been produced, which can be considered as candidates for load-bearing bone substitute materials.

πŸ“œ SIMILAR VOLUMES

Rheological properties of glass bead-fil
Rheological properties of glass bead-filled low-density polyethylene composite melts in capillary extrusion
✍ Ji-Zhao Liang; R. K. Y. Li πŸ“‚ Article πŸ“… 1999 πŸ› John Wiley and Sons 🌐 English βš– 154 KB πŸ‘ 2 views

The melt flow of glass bead-filled low-density polyethylene composites in extrusion have been observed by using a capillary rheometer to investigate the effects of temperature, shear rate, and filler content on the rheological properties of the melts. The results show that the melt shear flow obeys

Positron annihilation studies of polyeth
Positron annihilation studies of polyethylene filled with ultrasil
✍ J. Tiňo; J. KriΕ‘tiak; Z. HlouΕ‘kova; O. Ε auΕ‘a πŸ“‚ Article πŸ“… 1993 πŸ› Elsevier Science 🌐 English βš– 226 KB

Akstract--Changes in polyethylene (PE) when filled with Ultrasil have been studied by the method of positron annihilation. The results show that the temperature dependence z3 is almost the same for all samples. Changes, however, occur in the intensities/3 and 12./3 has the highest values in pure PE

Die–swell behavior of glass bead-filled
Die–swell behavior of glass bead-filled low-density polyethylene composite melts at high extrusion rates
✍ Ji-Zhao Liang; R. K. Y. Li; C. Y. Tang; S. W. Cheung πŸ“‚ Article πŸ“… 2000 πŸ› John Wiley and Sons 🌐 English βš– 135 KB πŸ‘ 2 views

The extrudate swell behavior of glass bead-filled low-density polyethylene (LDPE) composite melts was investigated using a constant rate type of capillary rheometer at high extrusion rates and test temperatures varied from 140 to 170Β°C. The results show that the die swell ratio (B) of the melts incr