## ABSTRACTS that the shape and sharpness of the three-dimensional ( 101) and ( 112) reflection, respectively, are considerably developed with time, whereas the mean interlayer spacing as determined by the (004) line is not changed significantly for holding times longer than 15 min.
Graphitization of carbon beads under pressure
โ Scribed by M. Inagaki; K. Horii; S. Naka
- Publisher
- Elsevier Science
- Year
- 1975
- Tongue
- English
- Weight
- 571 KB
- Volume
- 13
- Category
- Article
- ISSN
- 0008-6223
No coin nor oath required. For personal study only.
โฆ Synopsis
Non-graphitizing carbon beads were heat-treated to 1300" -1900" under 5 kbar. Whereas the original beads carbonized at looo" graphitize abruptly at 1500" -16CV, the pre-heated ones demand higher temperature for their graphitization. The 1500"-pre-heated and 2100"-pre-heated graphitized above 17M1", and the 2670"-pre-heated above 1900". In the H'IT range where the graphitization occurs, the following changes in texture were observed: after the appearance of cactus-like projections, necks form between beads, needles and tiny flakes appear and optically anisotropic areas grow in size. A remarkable densification was found for the pre-heated beads in the same HIT range.
๐ SIMILAR VOLUMES
A review of the recent work on acceleration of graphitization under high pressure
Structural changes which accompany the catalytic graphitization of carbon have been investigated. Utilizing X-ray diffraction and high temperature microscopy techniques, the effectiveness of various additives in promoting the formation of graphite from a variety of carbon materials of varying degree
## Linear strains at pressures up to 600 PSI (4.14 MPa) have been measured in uncoated and coated graphites at room temperature. The bulk moduli found in this way are found to be very dependent on the nature of the graphite. Two empirical equations relating modulus to porosity are applied to the d
The d-point bend strength and strain to fracture at room temperature have heen measured in three graphites at atmospheric pressure and at a gas pressure of 600 psi (4.14 MPa). The surface fracture stress was reduced under pressure by between 2 and 7%. and the fracture strain wa\ rcduccd hy bctneen I