Filling behavior of UV nanoimprint resin observed by using a midair structure mold

✍ Scribed by Jun Taniguchi; Ken-ichi Machinaga; Noriyuki Unno; Nobuji Sakai

• Publisher: Elsevier Science
• Year: 2009
• Tongue: English
• Weight: 647 KB
• Volume: 86
• Category: Article
• ISSN: 0167-9317
• DOI: 10.1016/j.mee.2008.12.085

✦ Synopsis

The filling behavior of resin during UV nanoimprint lithography (UV-NIL) was observed by using a ''midair structure mold" and by changing the imprint pressure. The midair structure molds were fabricated by electron beam lithography (EBL) using hydrogen silsesquioxane (HSQ) as a negative tone resist. After the fabrication of midair structure mold, two types of surface treatment molds, which were with or without release coating, were prepared. Using these molds, the filling behavior of a UV curable resin was investigated at various pressures. The results indicate that a pressure of approximately 1.2 MPa is necessary for complete filling in the case of molds treated with a release agent. This method demonstrates effect of a release coating for UV-NIL.