✦ LIBER ✦

Electrical discharge machining of tube-type parts

✍ Scribed by V. G. Davtyan; F. Kh. Kuliev; B. F. Vasil'chuk

Publisher: Springer
Year: 1973
Tongue: English
Weight: 406 KB
Volume: 9
Category: Article
ISSN: 0009-2355
DOI: 10.1007/bf01174398

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Repair of forging dies for bit parts by

Repair of forging dies for bit parts by electrical discharge machining

✍ M. Sh. Shteinbukh; S. E. Mayasova 📂 Article 📅 1989 🏛 Springer 🌐 English ⚖ 150 KB

Electrical discharge machining of cast m

Electrical discharge machining of cast metal matrix composites

✍ N.P. Hung; L.J. Yang; K.W. Leong 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 956 KB

Model of workpiece erosion for electrica

Model of workpiece erosion for electrical discharge machining process

✍ Leonid I. Sharakhovsky; Aruy Marotta; Alexei M. Essiptchouk 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 415 KB

The previously published step-wise model (SWM) of cold electrodes erosion of electric arc heaters (EAHs) was modified for the calculation of workpiece removal rate (WRR) in electrical discharge machining (EDM) process. Modified model applies both relations the step-wise erosion model and the point h

Dimensional analysis of tool wear in ele

Dimensional analysis of tool wear in electrical discharge machining

✍ M.L. Jeswani 📂 Article 📅 1979 🏛 Elsevier Science 🌐 English ⚖ 542 KB

An analysis of surface erosion in electr

An analysis of surface erosion in electrical discharge machining

✍ S. Tariq Jilani; P.C. Pandey 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 636 KB

Determination of optimal cutting paramet

Determination of optimal cutting parameters in wire electrical discharge machining

✍ Y.S. Tarng; S.C. Ma; L.K. Chung 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 535 KB