Electrical and microstructural properties of low-resistance Ti/Re/Au ohmic contacts to n-type GaN
✍ Scribed by Rajagopal Reddy, V. ;Choi, Chel-Jong
- Publisher
- John Wiley and Sons
- Year
- 2007
- Tongue
- English
- Weight
- 473 KB
- Volume
- 204
- Category
- Article
- ISSN
- 0031-8965
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
The microstructural and electrical properties of Ti/Re/Au (10 nm/10 nm/50 nm) ohmic contacts to moderately doped n‐type GaN (4.0 × 10^18^ cm^–3^) have been investigated by current–voltage (I –V), Auger electron microscopy (AES) and transmission electron microscopy (TEM). The electrical characteristics of as‐deposited and annealing at temperatures below 800 °C samples exhibit non‐linear behaviour. However, the sample showed ohmic behaviour when the contact is annealed at 900 °C for 1 min in nitrogen ambient. The Ti/Re/Au contacts give specific contact resistance as low as 8.6 × 10^–6^ Ω cm^2^ after annealing at 900 °C. It is shown that the surface of the as‐deposited contact is fairly smooth and slightly degraded when the contact is annealed at 900 °C. The Ti/Re/Au ohmic contact showed good edge acuity after annealing at 900 °C for 1 min. Based on the Auger electron microscopy and transmission electron microscopy results, possible ohmic formation mechanisms for the Ti/Re/Au contacts to the n‐type GaN are described and discussed. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)
📜 SIMILAR VOLUMES
## Abstract The effects of rapid thermal annealing on the electrical and structural properties of Pd/Au Schottky contacts to n‐type InP(111) have been investigated by current–voltage (__I__ –__V__), capacitance–voltage (__C__ –__V__) and X‐ray diffraction (XRD) measurements. The barrier height of t