✦ LIBER ✦

Effective temperature factor of carbons

✍ Scribed by M. Inagaki

Book ID: 102993409
Publisher: Elsevier Science
Year: 1972
Tongue: English
Weight: 140 KB
Volume: 10
Category: Article
ISSN: 0008-6223
DOI: 10.1016/0008-6223(72)90432-0

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Effect of temperature and distribution f

Effect of temperature and distribution function of depolarization factor on thermal conductivity of carbon nanotube-based composites

✍ Khordad, R.; Razi, F. 📂 Article 📅 2013 🏛 Elsevier Science 🌐 English ⚖ 532 KB

Factors influencing the formation of car

Factors influencing the formation of carbon on iron Fischer-Tropsch catalysts: II. The effect of temperature and of gases and vapors present during Fischer-Tropsch synthesis

✍ M.E Dry; T Shingles; L.J Boshoff; C.S van H. Botha 📂 Article 📅 1970 🏛 Elsevier Science 🌐 English ⚖ 543 KB

Effective Debye-Waller parameter of carb

Effective Debye-Waller parameter of carbons

✍ M. Inagaki; T. Higashi; Y. Sasaki; M. Toyoda; M. Sakai 📂 Article 📅 1986 🏛 Springer 🌐 English ⚖ 470 KB

Low temperature specific heat of carbons

✍ A.S. Vagh; K. Kamiya; S. Mrozowski 📂 Article 📅 1972 🏛 Elsevier Science 🌐 English ⚖ 129 KB

Neu! Y&Z). In extension of the work of Delhaes and Hisiyama\* measurements of specific heat in the range @5-5°K were carried out on soft carbons heattreated in the range 6~)-1600°C. A largp increase in the linear component with decrease in HTT is observed as well as also in the cubic component. The

Specific heat of soft carbons at room te

Specific heat of soft carbons at room temperature

✍ A.S. Vagh; S. Mrozowski 📂 Article 📅 1973 🏛 Elsevier Science 🌐 English ⚖ 158 KB

Studies of young's modulus of carbons at

Studies of young's modulus of carbons at high temperature

✍ J.F. Andrew; S. Sato 📂 Article 📅 1964 🏛 Elsevier Science 🌐 English ⚖ 813 KB

Preliminary results of measurements of the static Young's modulus for carbons at high temperature were reported previously. Since that time the apparatus was improved in reliability and in reproducibility. As previously the deflection of a specimen heated in a graphite tube furnace is obtained from