✦ LIBER ✦

Effective parameter for the selection of modifying agent for Al–Si alloy

✍ Scribed by H.S. Kang; W.Y. Yoon; K.H. Kim; M.H. Kim; Y.P. Yoon; I.S. Cho

Publisher: Elsevier Science
Year: 2007
Tongue: English
Weight: 653 KB
Volume: 449-451
Category: Article
ISSN: 0921-5093
DOI: 10.1016/j.msea.2006.02.363

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Behavior of the crystallization paramete

Behavior of the crystallization parameters for alloys of the system Al-Si near the lyotectic point

✍ A. N. Chichko; N. P. Yurkevich; V. F. Sobolev 📂 Article 📅 1993 🏛 Springer US 🌐 English ⚖ 257 KB

Simulation of Si concentration effect on

Simulation of Si concentration effect on the permeability for columnar dendrite structures during solidification of Al–Si alloy

✍ S.M.H. Mirbagheri; J. Silk 📂 Article 📅 2007 🏛 Elsevier Science ⚖ 326 KB

Selection of the optimum parameters for

Selection of the optimum parameters for spinning of modified acetate textile fibre

✍ A. Kh. Usmanov; I. B. Miroshnichenko; A. S. Sadykov; K. É. Érgashev 📂 Article 📅 1994 🏛 Springer US 🌐 English ⚖ 243 KB

On the evaluation of parameters of the c

On the evaluation of parameters of the constitutive equation for 7475 Al alloy

✍ M. K. Rao; A. K. Mukherjee 📂 Article 📅 1987 🏛 Springer 🌐 English ⚖ 583 KB

The effect of strain on the ageing time

The effect of strain on the ageing time for serrated yielding in an Al-Mg-Si alloy

✍ P.G. McCormick 📂 Article 📅 1974 🏛 Elsevier Science ⚖ 542 KB

The effect of discontinuous increases in strain rate on the yield behavior of specimens undergoing type A serrated yielding has been investigated. Above a critical increase in strain rate, a transition in the subsequent yield behavior, from further type A yielding to continuous yielding was observed

Selection of the optimum parameter for t

Selection of the optimum parameter for the control of heat-treatment processes of alloys

✍ M. G. Tartakovskii; V. A. Golichenko; I. V. Ryabikova 📂 Article 📅 1988 🏛 Springer US 🌐 English ⚖ 458 KB