๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Effect of Various Treatments on Carbon Fiber Surfaces Studied by Raman Microprobe Spectrometry

โœ Scribed by Cuesta, A.; Dhamelincourt, P.; Laureyns, J.; Martinez-Alonso, A.; Tascon, J. M. D.

Book ID
115363379
Publisher
Society for Applied Spectroscopy
Year
1998
Tongue
English
Weight
159 KB
Volume
52
Category
Article
ISSN
0003-7028

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

221. Characterization of carbon-carbon c
221. Characterization of carbon-carbon composites by raman microprobe. I. Studies on graphitization
โœ A. Marchand; P. Lespade; M. Couzi ๐Ÿ“‚ Article ๐Ÿ“… 1982 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 143 KB

The work-of-fracture (ywOF) of carbon-carbon composites was measured for composites with 3-D woven fiber preforms, carbon felts, and chopped fibers. Maximum values were observed for the 3-D preforms and minimum values for the carbon felts. The values are also compared with similar data for graphites

Study of carbon fiber surfaces by scanni
Study of carbon fiber surfaces by scanning tunneling microscopy, part III. Carbon fibers after surface treatments
โœ Ren-Yan Qin; Jean-Baptiste Donnet ๐Ÿ“‚ Article ๐Ÿ“… 1994 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 905 KB

The effect of surface treatments on carbon fibers has been studied by scanning tunneling microscopy (STM). The results show that over a wide range of oxidation degrees the anodic or electrochemical oxidation does not change the surface aspects, neither at microscopic scale nor at nanometric scale, w