✦ LIBER ✦

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip model

✍ Scribed by A.R. Watson

Publisher: Elsevier Science
Year: 1985
Weight: 922 KB
Volume: 25
Category: Article
ISSN: 0020-7357
DOI: 10.1016/0020-7357(85)90035-6

No coin nor oath required. For personal study only.

✦ Synopsis

A model to predict the torque and thrust in drilling by the cutting lips is developed from an oblique machining model assuming that a number of individual elements can represent the material being machined by each lip.

📜 SIMILAR VOLUMES

Drilling model for cutting lip and chise

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip model

✍ A.R. Watson 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 922 KB

Drilling model for cutting lip and chise

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. II — revised cutting lip model

✍ A.R. Watson 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 488 KB

Drilling model for cutting lip and chise

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. IV — drilling tests to determine chisel edge contribution to torque and thrust

✍ A.R. Watson 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 719 KB