✦ LIBER ✦

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip model

✍ Scribed by A.R. Watson

Publisher: Elsevier Science
Year: 1985
Weight: 922 KB
Volume: 25
Category: Article
ISSN: 0020-7357
DOI: 10.1016/0020-7357(85)90035-6

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Drilling model for cutting lip and chise

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip model

✍ A.R. Watson 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 922 KB

A model to predict the torque and thrust in drilling by the cutting lips is developed from an oblique machining model assuming that a number of individual elements can represent the material being machined by each lip.

Drilling model for cutting lip and chise

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. II — revised cutting lip model

✍ A.R. Watson 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 488 KB

Drilling model for cutting lip and chise

Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. IV — drilling tests to determine chisel edge contribution to torque and thrust

✍ A.R. Watson 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 719 KB