✦ LIBER ✦

Door hole seal for vehicle and method for preparation and use

Publisher: Elsevier Science
Year: 2008
Tongue: English
Weight: 192 KB
Volume: 2008
Category: Article
ISSN: 1350-4789
DOI: 10.1016/s1350-4789(08)70251-4

No coin nor oath required. For personal study only.

✦ Synopsis

Carrier frame

📜 SIMILAR VOLUMES

Method and system for applying a seal to

Method and system for applying a seal to a door of a motor vehicle

📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 90 KB

An oil seal is described that has a pair of concentric seal lips contained in a rotating housing and a stationary flange between them. The inner lip does not contact the stationary flange when the shaft is stationary but moves to close the gap, presumably due to centrifugal force. A wide selection o

Bearing, sensor and seal for motor vehic

Bearing, sensor and seal for motor vehicles

📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 233 KB

Seal method and seal for mechanical equi

Seal method and seal for mechanical equipment

📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 306 KB

This patent describes a seal arrangement for the attachment of an impeller to the bottom entry spindle of a blender or small chemical mixer.

Seal assembly and method for sealing

📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 107 KB

A mechanical seal is described that uses an elastomer bellows as the spring. This is to assist with providing an even face loading and improved resistance to clogging compared with typical coil spring designs.

Hole packer and seal for oil and gas wel

Hole packer and seal for oil and gas wells

📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 190 KB

A series of alternative designs for the attachment of the seal housing to a large slurry pump is covered by this patent. The purpose is to improve pump efficiency and maintenance, and overcome problems associated with lifting into place replacement seal housings. The housing can be adjustable and he

Face seal and method of making, for use

Face seal and method of making, for use in refrigeration compressors

📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 118 KB

## Burgmann Industries GmbH & Co KG, Germany A method and a device are disclosed for determining the current operating conditions of a mechanical face seal. Measurements of the heat flow are taken between at least two selected measurement points M1, M2, M3, M4 on the stationary seal ring. By evalu