Divertor modelling of septum assessment experiments in JET MkIIGB
β Scribed by E. Tsitrone; P. Andrew; X. Bonnin; P. Coad; D. Coster; W. Fundamenski; P. Ghendrih; A. Huber; S. Jachmich; A. Kukushkin; A. Loarte; G. Matthews; R. Pitts; J. Rapp; D. Reiter; M. Stamp; M. Wischmeier; contributors to the JET EFDA work programme
- Publisher
- John Wiley and Sons
- Year
- 2004
- Tongue
- English
- Weight
- 138 KB
- Volume
- 44
- Category
- Article
- ISSN
- 0005-8025
No coin nor oath required. For personal study only.
β¦ Synopsis
Abstract
We present results obtained from modeling the septum assessment experiments of the JET MkIIGB divertor with the B2βEirene code package. Similar Lβmode discharges have been performed with and without septum, varying density and gas puffing location. High and low inner wall clearance simulations are also compared, as this parameter has been shown experimentally to play an important role in the final density limit. According to the simulations, the neutrals ionization pattern is not affected by the septum, consistent with experiment. The septum does improve the pumped particle flux in the outer divertor, the inner divertor results depending on plasmaβwall clearance, but this only concerns a small fraction of the recycling flux at the targets (less than 2%) and does not influence the overall divertor plasma very much. Comparison between inner and outer gas fuelling with a moderate gas puff rate shows no difference in the simulations without septum, while a slight asymmetry is observed in the simulations with septum, showing that the septum allows acting separately on the inner and outer divertor. We conclude that a neutral flow exists linking outer and inner divertors with particles travelling around the plasma in the main chamber. (Β© 2004 WILEYβVCH Verlag GmbH & Co. KGaA, Weinheim)
π SIMILAR VOLUMES
The Technology Acceptance Model (TAM) is widely used by researchers and practitioners to predict and explain user acceptance of information technologies . TAM models system usage intentions and behavior as a function of perceived usefulness and perceived ease of use . The original scales for measur
## Abstract The effects of thermomechanical properties of dissimilar polymer plates on thermal bonding were investigated and the resultant deformation of cover Topas COC plate was modeled using a simplified quasiβcreep model. The appropriate conditions for thermal bonding for minimal deformation of
David and Wllermaux (1987,1989) and Muhr et al. (1990) have developed and applied a multizone mixing model (MZM) for semi-batch single jet mixing in stirred tanks. The aim of the present paper is to generalize the multizone model (MZM) to the case of a semi-batch stirred tank with two separate feeds