✦ LIBER ✦

Development of the Transistor Inverter at 20 KC Using Power Transistors

✍ Scribed by Martin, Warren A.

Book ID: 114562395
Publisher: Institute of Electrical and Electronics Engineers
Year: 1957
Tongue: English
Weight: 948 KB
Volume: I-6
Category: Article
ISSN: 0096-2260
DOI: 10.1109/ire-i.1957.5006686

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Improved power regenerative controls by

Improved power regenerative controls by using thyristor rectifier bridge of voltage source inverter and a switching transistor

✍ Matsui, K.; Mizuno, U.; Murai, Y. 📂 Article 📅 1992 🏛 IEEE 🌐 English ⚖ 561 KB

On the development of CAD techniques sui

On the development of CAD techniques suitable for the design of high-power RF transistors

✍ Aaen, P.H.; Pla, J.A.; Balanis, C.A. 📂 Article 📅 2005 🏛 IEEE 🌐 English ⚖ 764 KB

Improved switch time of I2L at low power

Improved switch time of I2L at low power consumption by using a SiGe heterojunction bipolar transistor

✍ M. Karlsteen; M. Willander 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 720 KB

Power dissipation calculation of the bas

Power dissipation calculation of the base spreading and contact resistance of transistors at low currents and low frequencies

✍ Valsamakis, E.A. 📂 Article 📅 1986 🏛 IEEE 🌐 English ⚖ 719 KB

The measurement of alkaline phosphatase

The measurement of alkaline phosphatase at nanomolar concentration within 70 s using a disposable microelectrochemical transistor

✍ Y Astier; P.N Bartlett 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 973 KB

Two-dimensional modeling of high-speed b

Two-dimensional modeling of high-speed bipolar transistors at high current densities using the integral charge-control relation

✍ M. Schröter; H.-M. Rein 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 288 KB

It is demonstrated both by numerical two-dimensional transistor simulation and by experiment that the Integral Charge-Control Relation (ICCR) is well suited for modeling high-speed bipolar transistors even at very high current densities. For this, the one-dimensional version proposed by Gumme] was m