X-rays scattered from a material contain information on the composition of the sample. The relationship between the sample composition and the amount of scattered radiation was studied for low-Z materials. Use of Comptonscattered tubelines appears to be the preferred technique and a calibration is p
Determination of light elements using x-ray spectrometry. Part II—Boron in glass
✍ Scribed by Hans A. van Sprang; Mirjan H. J. Bekkers
- Publisher
- John Wiley and Sons
- Year
- 1998
- Tongue
- English
- Weight
- 222 KB
- Volume
- 27
- Category
- Article
- ISSN
- 0049-8246
No coin nor oath required. For personal study only.
✦ Synopsis
Two methods that allow the determination of the boron content in a glass or a Ñux were compared. The Ðrst method uses direct measurement of B Ka Ñuorescence and subsequent fundamental parameter-based quantiÐcation. Although it can be used for low concentrations of B, it requires extra care with calibration because the fundamental parameters for boron depend on the chemical environment. The second method relies on the use of Comptonscattered radiation to determine boron as a light fraction in an otherwise known matrix. This method does not require matrix-dependent calibration, but it is insensitive for boron concentrations below about 4% of The B 2 O 3 . preferred approach is a combination of both methods.
📜 SIMILAR VOLUMES
## Trace elements m oil can be determined by adsorption of the oil sample onto magnesium oxide followed by thermal degradation of the organic material. The resulting powder is easily pressed into a pellet suitable for x-ray spectrometric analysis. The lower limit of detection depends upon the trac
The determination of trace elements in mineral water by preconcentration with ammonium pyrrolidinedithiocarbamate (APDC) is described. Samples were spiked with an internal Ga standard and the precipitated dithiocarbamates of trace elements were separated by Ðltration through a Nuclepore Ðlter. A sma