## Abstract In this paper, a new reflectarray cell consisting of a variable‐length slot etched in a microstrip patch is presented. The phase shift is achieved by controlling the length of the slot. Two different structures are proposed: the first one uses a single patch with a single slot while the
Design and measurement of new reflectarray antenna using microstrip patches loaded with slot
✍ Scribed by Cadoret, D.; Laisné, A.; Gillard, R.; Le Coq, L.; Legay, H.
- Book ID
- 120177528
- Publisher
- The Institution of Electrical Engineers
- Year
- 2005
- Tongue
- English
- Weight
- 884 KB
- Volume
- 41
- Category
- Article
- ISSN
- 0013-5194
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
## Abstract This paper proposes a new method for designing a microstrip‐antenna reflectarray. The array is a set of slotted rectangular microstrip antennas with one or two vias connected to the ground plane. Different techniques may be used to control the phase of the reflected wave, either by adju
mum is in the end-fire direction with higher cross-polar level and a gain of 3 dBi is observed over the VSWR BW. The area of the proposed compact MSA is 15 cm 2 , which is only 6% of the corresponding unslotted RMSA, which results in a better BW but a reduced gain. ## 6. CONCLUSION A compact varia
## Abstract In this paper, a new ultra‐wideband slot antenna with a simplified feeding network is presented. This antenna is composed of a circular slot coupled to a circular patch fed with 50Ω microstrip line. A proper parametric investigation was carried out for optimization of the proposed struc