✦ LIBER ✦

Cutting performance of CrN-based coatings tool deposited by hybrid coating method for micro drilling applications

✍ Scribed by M.C. Kang; S.K. Je; K.H. Kim; B.S. Shin; D.H. Kwon; J.S. Kim

Book ID: 108278468
Publisher: Elsevier Science
Year: 2008
Tongue: English
Weight: 607 KB
Volume: 202
Category: Article
ISSN: 0257-8972
DOI: 10.1016/j.surfcoat.2008.06.130

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Cutting performance of CrN and Cr-Si–N c

Cutting performance of CrN and Cr-Si–N coated end-mill deposited by hybrid coating system for ultra-high speed micro machining

✍ S.H. Shin; M.W. Kim; M.C. Kang; K.H. Kim; D.H. Kwon; J.S. Kim 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 602 KB

## Hybrid coating system Cr-Si-N coatings Micro end-milling Ultra-high speed machining Tool performance In this paper, comparative studies on the properties and cutting performance between CrN and Cr-Si-N coated micro end-mill for ultra-high speed machining applications were conducted. Ternary Cr-S

Mechanical properties and cutting perfor

Mechanical properties and cutting performance of Cr–Al–N hybrid coated micro-tool for micro high-speed machining of flexible fine die

✍ Kim, M.W.; Kim, K.H.; Kang, M.C.; Cho, S.H.; Ryu, K.T. 📂 Article 📅 2012 🏛 Elsevier Science 🌐 English ⚖ 622 KB

Properties and tool performance of ta-C

Properties and tool performance of ta-C films deposited by double-bend filtered cathodic vacuum arc for micro drilling applications

✍ Kang, M.C.; Tak, H.S.; Jeong, Y.K.; Lee, H.W.; Kim, J.S. 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 708 KB