✦ LIBER ✦

Critical discussion of the use of adsorption measurements from the liquid phase for surface area estimation

✍ Scribed by G Schay; L.G Nagy

Publisher: Elsevier Science
Year: 1972
Tongue: English
Weight: 819 KB
Volume: 38
Category: Article
ISSN: 0021-9797
DOI: 10.1016/0021-9797(72)90247-0

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The Use of Liquid Phase Adsorption Isoth

The Use of Liquid Phase Adsorption Isotherms for Characterization of Activated Carbons

✍ Suryadi Ismadji; Suresh K. Bhatia 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 437 KB

The characterization of three commercial activated carbons was carried out using the adsorption of various compounds in the aqueous phase. For this purpose the generalized adsorption isotherm was employed, and a modification of the Dubinin-Radushkevich pore filling model, incorporating repulsive con

Adsorption of toluene vapor on glass pla

Adsorption of toluene vapor on glass plates and surface area estimation from the adsorption isotherm gradient at the linear portion

✍ Akira Nonaka 📂 Article 📅 1986 🏛 Elsevier Science 🌐 English ⚖ 570 KB

A novel method for surface area estimati

A novel method for surface area estimation from the linear portion gradient of the type II adsorption isotherms using toluene and ethylbenzene vapors

✍ Akira Nonaka 📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 346 KB

Calculation of the BET-Compatible Surfac

Calculation of the BET-Compatible Surface Area from Any Type I Isotherms Measured above the Critical Temperature

✍ József Tóth 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 80 KB

In our previous papers [Tóth, J., et al., J. Colloid Interface Sci. 212, 402 (1999); 212, 411 (1999)] it has been proven that a BET-compatible specific surface area, a(s)(c)(N(2), 77), can be calculated from any Type I monolayer isotherms and from the monolayer domain of Type II isotherms, both meas

Calculation of the BET Compatible Surfac

Calculation of the BET Compatible Surface Area from Any Type I Isotherms Measured below the Critical Temperature

✍ József Tóth; Ferenc Berger; Imre Dékány 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 107 KB

It may occur in practice that the nitrogen isotherm should be measured at 77 K only in order to determine the Brunauer-Emmett-Teller (BET) specific surface area [as(N2, 77)]. This fact has given cause for an elaborate method to calculate the value of as(N2, 77) from Type I isotherms measured on any

Calculation and Prediction of Adsorption

Calculation and Prediction of Adsorption Excesses on the Ternary Liquid Mixture/Air Interface from Surface Tension Measurements

✍ Grit Kalies; Peter Bräuer; Annette Schmidt; Ulf Messow 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 329 KB

The surface tensions of the n-propanol/ethylene glycol/water ternary mixture and its binary mixtures are measured at 293 K and described by mathematical functions. The experimental data and their descriptions are shown in the three-dimensional space by means of coordinate transformation. A thermodyn