Relaxations in poly(etherimide) PEI Ultem 1000 have been analysed by di †erential scanning calorimetry (DSC), dynamic mechanical spectroscopy (DMS), dielectric relaxation spectroscopy (DRS) and thermally stimulated depolarization current (TSDC) measurements. DMTA and DRS results show three distinct
Comparative study of mechanical and electrical relaxations in poly(etherimide). Part 2
✍ Scribed by Díaz Calleja, R.; Friederichs, S.; Jaímes, C.; Sanchis, M. J.; Belana, J.; Cañadas, J. C.; Diego, J. A.; Mudarra, M.
- Publisher
- John Wiley and Sons
- Year
- 1998
- Tongue
- English
- Weight
- 407 KB
- Volume
- 46
- Category
- Article
- ISSN
- 0959-8103
No coin nor oath required. For personal study only.
✦ Synopsis
The curves describing the relaxation behaviour of poly(etherimide) at several frequencies shows in the dielectric lossÈtemperature plot c and b relaxations centred at [95¡C and 100¡C, respectively, at 10 Hz. The glassÈrubber relaxation or a process appears at 225¡C at 10 Hz ; at this temperature free charge conductivity and blocking electrode phenomena become dominant at frequencies below 10 Hz. The same three relaxations are observed by dynamic mechanical thermal analysis (DMS). The strength of the c and a relaxations can be estimated from the Ðtting of empirical relaxation functions, such as the FuossÈ Kirkwood and HavriliakÈNegami equations, to the dielectric data measured in the frequency domain. An electric model was used to separate the dipolar response from conductivity contributions in the glassÈrubber relaxation. Finally, the e †ect of water on the low-temperature relaxation has been demonstrated by dielectric and mechanical measurements.
1998 SCI.
📜 SIMILAR VOLUMES
## Abstract Bio‐based PTT and PTT blends with PEEA of two different ion contents (275 ppm Na and 3515 ppm Na) and PEG 400 bis (2‐ethylhexanoate) were prepared by melt processing. The blends were characterized by differential scanning calorimetry, dynamic mechanical analysis, transmission electron m