✦ LIBER ✦

Characterization and analysis of continuous recycle systems: Part II. Cascade

✍ Scribed by Uzi Mann; Michael Rubinovitch

Publisher: American Institute of Chemical Engineers
Year: 1981
Tongue: English
Weight: 694 KB
Volume: 27
Category: Article
ISSN: 0001-1541
DOI: 10.1002/aic.690270518

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Characterization and analysis of continu

Characterization and analysis of continuous recycle systems

✍ Uzi Mann; Michael Rubinovitch; Edwin J. Crosby 📂 Article 📅 1979 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 896 KB

## Abstract A general analysis of continuous recycle systems and models is presented by considering the fluid history inside the systems. The history of a fluid element is expressed in terms of the number of cycles it completes, its residence time in the system and the total time it resides in a sp

Part II: Reaction rate studies and the a

Part II: Reaction rate studies and the analysis of batch esterification in two phase systems

📂 Article 📅 1981 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 621 KB

## Abstract The kinetics of the esterification of n‐butyl alcohol with acetic acid has been studied experimentally in concentrated solutions at near ambient temperature in the presence of a sulphuric acid catalyst and the rate constants for the forward and reverse reaction determined. The rate dat

Woven fabric composites—part II: Charact

Woven fabric composites—part II: Characterization of macro-crack initiation loads for global damage analysis

✍ Jaehyon Choi; Kumar K. Tamma 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 128 KB

Characterization of resins prepared by p

Characterization of resins prepared by polycondensation of Egyption bagasse pith and bisphenol A. Part II. Elemental analysis and thin layer chromatography

✍ S. M. Sayyah; S. M. Saad; E. Elwy 📂 Article 📅 1990 🏛 John Wiley and Sons 🌐 English ⚖ 511 KB

Vibration Analysis Of A Motor-flexible C

Vibration Analysis Of A Motor-flexible Coupling-Rotor System Subject To Misalignment And Unbalance, Part II: Experimental Validation

✍ M. Xu; R.D. Marangoni 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 332 KB

AE—Automation and Emerging Technologies:

AE—Automation and Emerging Technologies: The Development of a Depth Control System for a Peat Milling Machine, Part II: System Optimization and Analysis

✍ S.F. Condon; S.M. Ward; N.M. Holden; A. McGee 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 425 KB

Optimization of the performance of a closed-loop, milling depth control system for a peat milling machine was undertaken. The system was optimized using a proportional-integral-derivative (PID) controller, set at a proportional gain of 50, and derivative and integral times of 0)5 and 0)89 s, respect