✦ LIBER ✦

Birefringence of high-pressure injection-molded high-density polyethylene at 70.5 μm wavelength

✍ Scribed by Jacobsson, Stellan ;Hård, Sverker ;Boldizar, Antal

Publisher: Wiley (John Wiley & Sons)
Year: 1984
Tongue: English
Weight: 196 KB
Volume: 22
Category: Article
ISSN: 0098-1273
DOI: 10.1002/pol.1984.180220309

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Influence of mold design on the mechanic

Influence of mold design on the mechanical properties of high-pressure injection—molded polyethylene

✍ J. Kubáut; J.-A. Månson; M. Rigdahl 📂 Article 📅 1983 🏛 Society for Plastic Engineers 🌐 English ⚖ 580 KB

The effect of annealing at 135° on the m

The effect of annealing at 135° on the mechanical properties of injection molded high density polyethylene-polypropylene blends

✍ R. A. Varin; D. Djokovic 📂 Article 📅 1988 🏛 Society for Plastic Engineers 🌐 English ⚖ 759 KB

Influence of mold filling rate and gate

Influence of mold filling rate and gate geometry on the modulus of high pressure injection-molded polyethylene

✍ A. Boldizar; J. Kubát; M. Rigdahl 📂 Article 📅 1990 🏛 John Wiley and Sons 🌐 English ⚖ 487 KB 👁 1 views

High pressure injection molding of HDPE with relatively high molecular weight is known to give products with significantly increased modulus and strength. The extent of this improvement is reduced when the thickness of the molded sample increases. The present paper is an account of experiments with