✦ LIBER ✦

Backgrounds and use of the computer aided geometric design system GTS

✍ Scribed by J. Janse

Publisher: Elsevier Science
Year: 1982
Tongue: English
Weight: 303 KB
Volume: 3
Category: Article
ISSN: 0166-3615
DOI: 10.1016/0166-3615(82)90042-2

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Interactive computer-aided design and th

Interactive computer-aided design and the DECIDE system

✍ A.W. Beeby; H.P.J. Taylor 📂 Article 📅 1976 🏛 Elsevier Science 🌐 English ⚖ 480 KB

A close look is taken into the mechanism of design processes and the value of man-machine interactive methods shown. The paper describes an interactive system for reinforced concrete design, the DECIDE system, which uses the smallest machines appropriate for such methods, namely, programmable desk t

Geometric modelling as an integral part

Geometric modelling as an integral part of computer aided design and manufacturing systems

✍ Øyvind Bjørke 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 303 KB

A geometric investigation of the rationa

A geometric investigation of the rational Bezier scheme of computer aided design

✍ L. Piegl 📂 Article 📅 1986 🏛 Elsevier Science 🌐 English ⚖ 549 KB

Geometric and biomechanical analysis for

Geometric and biomechanical analysis for computer-aided design of assistive medical devices

✍ Taeseung D. Yoo; Eunyoung Kim; JungHyun Han; Daniel K. Bogen 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 668 KB

This paper presents geometric and biomechanical analysis for designing elastic braces used to restrict the motion of injured joints. Towards the ultimate goal of the brace research, which is to design custom-made braces of the stiffness prescribed by a physician, this paper presents an analysis of t

Computer-aided design of control systems

Computer-aided design of control systems using nonparametric models

✍ Jianhua Pan; J. Van de Vegte 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 318 KB

A method based on the use of the impulse response as a nonparametrie or graphical model is proposed for the analysis and design of linear time-invariant control systems. It can be used for systems too complex to be represented adequately by parametric models. The technique is restricted here to sing

The use of computer aided design techniq

The use of computer aided design techniques in printed circuit layouts

✍ C.B. Besant; A. Hamlyn; P.M. McLintock 📂 Article 📅 1973 🏛 Elsevier Science 🌐 English ⚖ 584 KB

Modern printed circuits are manufactured using a mask. This mask can be prepared by directin~ a light beam around a photographic plate to describe the required circuit. An etching process is then used to transfer the circuit from the photographic plate (the mask) to the circuit board. A description