✦ LIBER ✦

Analysis of stub-girders using substructuring

✍ Scribed by M.M. Hrabok; M.U. Hosain

Publisher: Elsevier Science
Year: 1978
Tongue: English
Weight: 430 KB
Volume: 8
Category: Article
ISSN: 0045-7949
DOI: 10.1016/0045-7949(78)90099-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Nonlinear analysis of stub-girders using

Nonlinear analysis of stub-girders using finite element method

✍ K. Padmanaban; C.M. Wang; N.E. Shanmugam; S.L. Lee 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 596 KB

On nonlinear dynamic analysis using subs

On nonlinear dynamic analysis using substructuring and mode superposition

✍ Klaus-Jürgen Bathe; Sheryl Gracewski 📂 Article 📅 1981 🏛 Elsevier Science 🌐 English ⚖ 767 KB

Buckling analysis of large and complex s

Buckling analysis of large and complex structures by using substructuring techniques

✍ J. Huang; T.-L. Wang 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 490 KB

AN EFFICIENT CRANKSHAFT DYNAMIC ANALYSIS

AN EFFICIENT CRANKSHAFT DYNAMIC ANALYSIS USING SUBSTRUCTURING WITH RITZ VECTORS

✍ Z.P. MOURELATOS 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 420 KB

A structural analysis using dynamic substructuring with Ritz vectors is presented for predicting the dynamic response of an engine crankshaft, based on the "nite-element method. A two-level dynamic substructuring is performed using a set of load-dependent Ritz vectors. The rotating crankshaft is pro

Analysis of prestressed girders with ope

Analysis of prestressed girders with openings

✍ H. Abdalla; J.B. Kennedy 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 596 KB

Analysis and design of stub bandpass fil

Analysis and design of stub bandpass filters using tapped-line geometry

✍ Tae-Soon Yun; Yong-Kyu Yoon; Byungje Lee; Jin-Joo Choi; Jin-Young Kim; Jong-Chul 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 359 KB

## Abstract A simplified mathematical design method for tapped‐line geometry is presented and the stub bandpass filters (BPFs) of λ~g~/4 and λ~g~/2 stubs with a center frequency of 5.8 GHz and a bandwidth of 5% are successfully designed, fabricated, and characterized using this approach. Design par