๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Aerial oxidation of hydrazines to nitrosamines

โœ Scribed by George Lunn; Eric D. Sansone; A. W. Andrews; E. Zeiger


Publisher
John Wiley and Sons
Year
1991
Tongue
English
Weight
308 KB
Volume
17
Category
Article
ISSN
0893-6692

No coin nor oath required. For personal study only.

โœฆ Synopsis


When 1,l -dimethylhydrazine and N-aminopiperidine were deliberately exposed to air substantial amounts of the corresponding carcinogenic nitrosamines were formed. Unoxidized samples of 1,l -dimethylhydrazine were not mu-tagenic while oxidized samples (which contained much higher levels of nitrosamines) were mutagenic. Both unoxidized and oxidized samples of N-ominopiperidine were mutagenic.


๐Ÿ“œ SIMILAR VOLUMES


Oxidation of Hydrazines with Nitrosoaren
โœ Kunio Kano; Masahiro Koga; Jean-Pierre Anselme ๐Ÿ“‚ Article ๐Ÿ“… 2010 ๐Ÿ› Wiley (John Wiley & Sons) โš– 255 KB
The aerial oxidation of scottish shale w
โœ Pettet, A. E. J. ;Greaves, W. S. ๐Ÿ“‚ Article ๐Ÿ“… 1947 ๐Ÿ› Wiley (John Wiley & Sons) โš– 490 KB

## Abstract In the aerial oxidation of Scottish shale wax a satisfactory rate of oxidation was attained by oxidising a mixture of 60% fresh wax with 40% unsaponifiable material from previous runs, at a temperature of 110ยฐ. Air for oxidation at the rate of 4 cu. ft./hour/100 g. mixture, was best int

The aerial oxidation of trivalent chromi
โœ Nyholm, R. S. ๐Ÿ“‚ Article ๐Ÿ“… 1947 ๐Ÿ› Wiley (John Wiley & Sons) โš– 390 KB ๐Ÿ‘ 1 views

## Abstract The oxidation of trivalent chromium in aqueous solution using atmospheric oxygen has been studied. Thermodynamically it has been shown that the oxidation is feasible at __pH__ values greater than 4. In practice the oxidation could be made to proceed only in very alkaline solution with t

Amination of Hydrazines to Yield Triazan
โœ Prof. Dr. Ernst Schmitz; Dipl.-Chem. S. Schramm; Dipl.-Chem. Heide Simon ๐Ÿ“‚ Article ๐Ÿ“… 1966 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 198 KB

Siebert also gives a formula for the determination of the bond order b from the single-bond value f l : b = rbfhiri ri Moreover, we can tibe an even simpler relationship b = fb/fl up to b = 1.5 whenever the distances rl and Tb are not known. However, for bond orders over 1.5, we must use the formula