𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Advancements in High Pressure Die Casting of Magnesium

✍ Scribed by H. Gjestland; H. Westengen

Publisher
John Wiley and Sons
Year
2007
Tongue
English
Weight
951 KB
Volume
9
Category
Article
ISSN
1438-1656

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Role of Manganes in the Soldering Reacti
Role of Manganes in the Soldering Reaction in Magnesium High Pressure Die Casting
✍ C. Tang; M. Jahedi; M. Brandt πŸ“‚ Article πŸ“… 2003 πŸ› John Wiley and Sons 🌐 English βš– 234 KB πŸ‘ 1 views

The significance of soldering in high pressure die casting (HPDC) of magnesium alloys could have a major economic impact on die casters and a study of the soldering phenomenon during HPDC of magnesium alloys has been undertaken. In this paper results of dip tests are presented involving the immersio

Casting Defects and Mechanical Propertie
Casting Defects and Mechanical Properties of High Pressure Die Cast Mg-Zn-Al-RE Alloys
✍ Wenlong Xiao; Mark A. Easton; Suming Zhu; Matthew S. Dargusch; Mark A. Gibson; S πŸ“‚ Article πŸ“… 2011 πŸ› John Wiley and Sons 🌐 English βš– 1020 KB

## Abstract The die casting defects and tensile properties of high pressure die cast (HPDC) Mg‐Zn‐Al‐RE alloys with various combinations of Zn and Al were studied. The results show that die casting defects in Mg‐Zn‐Al‐RE alloys are affected by the percentage of Zn and Al contents. The hot tearing s

Determination of magnesium and aluminium
Determination of magnesium and aluminium in zinc-base die-casting alloys
✍ L. Bloch πŸ“‚ Article πŸ“… 1961 πŸ› Elsevier Science 🌐 English βš– 46 KB

## 404 SHORT COMMUNICATION i.e. 96,5oo C/o.5 mole of water) amounts to 17. 9 pA for each mg of water present per cubic meter gas at 760 mm and 20 Β°. Expressing the water content in p.p.m. (v/v), this factor becomes 13.4 pA. The range of the cell is from 5-2000 mg of water per cubic meter. Both the