Adsorption of Molybdenum on Titania from Aqueous Solutions

✍ Scribed by Gamal M.S. El Shafei; Christine A. Philip; Nabawaya A. Moussa

• Publisher: Elsevier Science
• Year: 2001
• Tongue: English
• Weight: 78 KB
• Volume: 234
• Category: Article
• ISSN: 0021-9797
• DOI: 10.1006/jcis.2000.7257

✦ Synopsis

The adsorption of Mo from dilute aqueous solutions (10(-3) to 3x10(-2) M) is effected on three samples of titania, two are anatase and the third is P25, which is composed of rutile and anatase. The adsorption isotherms at 298, 318, and 338 K are analyzed using a Langmuir linear equation. The isotherms on P25 showed a distinct inflection point that is reproduced by two linear portions, indicating different adsorption regimes. This adsorption behavior is explained as follows: with low amount adsorbed the adsorption is initiated by protonation of the basic hydroxyls on which the negatively charged MoO(4)(2-')s are adsorbed, and this is accompanied by an increase in the pH of the impregnating solution. At higher adsorption the coordinatively unsaturated Ti(4+) sites participate in the process, leading to a decline in the initial increase in pH. In the case of the two anatase samples the low surface area resulted in poor distribution of adsorption sites; consequently, the distinction between the two modes of adsorption was not entirely clear. The higher adsorption site density in the case of anatase is accompanied by a lower surface coverage, θ, than that for P25. The heat of adsorption, Q, on the three titania samples showed a linear increase with θ, which is represented by the regression equation: -Q=95.77θ-4.25 (R(2)=0.993). Copyright 2001 Academic Press.