𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Active vibration μ-synthesis-control of a hydrostatically supported flexible beam

✍ Scribed by Peter Kytka; Christian Ehmann; Rainer Nordmann

Publisher
Springer-Verlag
Year
2007
Tongue
English
Weight
975 KB
Volume
21
Category
Article
ISSN
1738-494X

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A SPLINE-BASED STATE RECONSTRUCTION FOR
A SPLINE-BASED STATE RECONSTRUCTION FOR ACTIVE VIBRATION CONTROL OF A FLEXIBLE BEAM
✍ R. Setola 📂 Article 📅 1998 🏛 Elsevier Science 🌐 English ⚖ 259 KB

In this paper a technique for ''instantaneous'' reconstruction of state variables of a flexible beam is proposed. The reconstructor uses spline shape functions to interpolate the available measurements and to take into account the boundary conditions. Unlike usual dynamic observers, this technique d

CONTROL DESIGN OF ACTIVE VIBRATION ISOLA
CONTROL DESIGN OF ACTIVE VIBRATION ISOLATION USING μ -SYNTHESIS
✍ M.R. BAI; W. LIU 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 500 KB

Numerical and experimental investigations on active vibration isolation system are presented in this paper. Two con"gurations are implemented for a statically balanced three-mount system. To reduce the in#uence of payload dynamics and coupling among the control actuators, intermediate masses are add

Active Vibration Control of a Single Mas
Active Vibration Control of a Single Mass Rotor on Flexible Supports
✍ P.E. Allaire; D.W. Lewis; J.D. Knight 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 633 KB

This paper considers cibration control of a single massJle.uible rotor on damped flexiblesupports with actitiefeedback control. Both proportional and dericaticefeedback control are utilized. Free cibrations and unbalance response of the rotor-control system are determined. The effect oJ,f'proportion

ACTIVE POSITION CONTROL OF A FLEXIBLE SM
ACTIVE POSITION CONTROL OF A FLEXIBLE SMART BEAM USING INTERNAL MODEL CONTROL
✍ Y.-S. LEE; S.J. ELLIOTT 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 511 KB

The problem of controlling the position at the tip of a #exible cantilever beam to follow a command signal is considered, by using a pair of piezoelectric actuators at the clamped end. The beam is lightly damped and so the natural transient response is rather long, and also since the sensor and actu