✦ LIBER ✦

ACOUSTIC IMPEDANCE MEASUREMENT, PART II: A NEW CALIBRATION METHOD

✍ Scribed by J.-P. DALMONT

Publisher: Elsevier Science
Year: 2001
Tongue: English
Weight: 359 KB
Volume: 243
Category: Article
ISSN: 0022-460X
DOI: 10.1006/jsvi.2000.3429

No coin nor oath required. For personal study only.

✦ Synopsis

A calibration method for input impedance sensors which permits an accurate determination of the calibration parameters is presented. The method is based on the measurement of two closed tubes of di!erent lengths whose propagation constant is not required to be accurately known. This method is shown to be applicable to most of the impedance sensors in the literature and is extended to transfer impedance calibration which is needed for multi-post characterization. The method is applied to an impedance sensor using a half-inch microphone cartridge as a source of volume velocity. The attenuation constant of a straight tube is measured and shown to be less than 3% larger than results derived from theory of viscothermal dissipation. As an example of two-port characterization, the calibrated sensor, complete with a microphone for transfer impedance measurement, is used for the measurement of side hole parameters.

📜 SIMILAR VOLUMES

ACOUSTIC IMPEDANCE MEASUREMENT, PART I:

ACOUSTIC IMPEDANCE MEASUREMENT, PART I: A REVIEW

✍ J.-P. DALMONT 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 274 KB

In this review, impedance sensors are presented as linear sensors with two entries whose signals are in#uenced by both pressure and volume velocity. Pressure is generally measured with a microphone, therefore impedance sensors are classi"ed according to the way the volume velocity is determined or c

AN ANALYTICAL INVESTIGATION OF THE DIREC

AN ANALYTICAL INVESTIGATION OF THE DIRECT MEASUREMENT METHOD OF ESTIMATING THE ACOUSTIC IMPEDANCE OF A TIME-VARYING SOURCE

✍ K.S PEAT 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 230 KB

This paper presents an analytical investigation of the direct method of measurement of the source impedance of a linear time-variant source. The direct method yields a frequencydependent e!ective source impedance which is routinely used in a time-invariant analysis to determine the insertion loss of

AN ANALYTICAL INVESTIGATION OF THE INDIR

AN ANALYTICAL INVESTIGATION OF THE INDIRECT MEASUREMENT METHOD OF ESTIMATING THE ACOUSTIC IMPEDANCE OF A TIME-VARYING SOURCE

✍ K.S. PEAT; J.-G. IH 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 337 KB

This paper presents an analytical investigation into the relationship between the characteristics of a linear, time-variant acoustic source, and the e!ective source impedance and source strength which follow if one then assumes the source to be time invariant. It thus models the indirect measurement

A NEW METHOD FOR MEASURING THE BULK MODU

A NEW METHOD FOR MEASURING THE BULK MODULUS OF COMPLIANT ACOUSTIC MATERIALS

✍ F.M. GUILLOT; J. JARZYNSKI 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 206 KB

The chemistry of the Δ2-Dihydro-azoles P

The chemistry of the Δ2-Dihydro-azoles Part. II. A new method for the preparation of Δ2-thiazolines

✍ J. Nys; J. Libeer 📂 Article 📅 2010 🏛 Wiley (John Wiley & Sons) ⚖ 655 KB

A METHOD FOR THE VIBRATION ANALYSIS OF B

A METHOD FOR THE VIBRATION ANALYSIS OF BUILT-UP STRUCTURES, PART II: ANALYSIS OF THE PLATE-STIFFENED BEAM USING A COMBINATION OF FINITE ELEMENT ANALYSIS AND ANALYTICAL IMPEDANCES

✍ R.M. GRICE; R.J. PINNINGTON 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 346 KB

This is the second of two companion papers which collectively present a method for the analysis of complex structures built-up from sti! beams and #exible plates. The method separates the sti! parts of the structure (which support the vibration sources) and the #exible parts of the structure, models