𝔖 Bobbio Scriptorium
✦   LIBER   ✦

A velocity dependent effective angle method for calibration of X-probes at low velocities

✍ Scribed by Ole Martin Bakken; Per-Åge Krogstad

Publisher
Springer
Year
2004
Tongue
English
Weight
305 KB
Volume
37
Category
Article
ISSN
0723-4864

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A swinging arm calibration method for lo
A swinging arm calibration method for low velocity hot-wire probe calibration
✍ H. H. Bruun; B. Farrar; I. Watson 📂 Article 📅 1989 🏛 Springer 🌐 English ⚖ 410 KB

This paper describes a swinging arm calibration facility for the calibration of hot-wire probes at low velocities. During the motion of the probe the anemometer signal is recorded digitally using pre-set angle positions for the start and stop of the data acquisition. The evaluation method described

A rig for the static calibration of cons
A rig for the static calibration of constant-temperature hot wires at very low velocities
✍ M. Heikal; A. Antoniou; T.A. Cowell 📂 Article 📅 1988 🏛 Elsevier Science 🌐 English ⚖ 220 KB

A rig for the calibration of hot-wire anemometer probes at velocities below 1 m/s that uses a stepping motor to drive the probe at controlled velocities down the center of an enclosed channel is described. A typical calibration curve (over the range 0.02-1 m/s) displays the usual characteristics of