𝔖 Bobbio Scriptorium
✦   LIBER   ✦

A simple method for low-speed hot-wire anemometer calibration

✍ Scribed by Yue, Zou; Malmström, Tor G

Book ID
120594174
Publisher
Institute of Physics
Year
1998
Tongue
English
Weight
127 KB
Volume
9
Category
Article
ISSN
0957-0233

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A swinging arm calibration method for lo
A swinging arm calibration method for low velocity hot-wire probe calibration
✍ H. H. Bruun; B. Farrar; I. Watson 📂 Article 📅 1989 🏛 Springer 🌐 English ⚖ 410 KB

This paper describes a swinging arm calibration facility for the calibration of hot-wire probes at low velocities. During the motion of the probe the anemometer signal is recorded digitally using pre-set angle positions for the start and stop of the data acquisition. The evaluation method described

A rig for the static calibration of cons
A rig for the static calibration of constant-temperature hot wires at very low velocities
✍ M. Heikal; A. Antoniou; T.A. Cowell 📂 Article 📅 1988 🏛 Elsevier Science 🌐 English ⚖ 220 KB

A rig for the calibration of hot-wire anemometer probes at velocities below 1 m/s that uses a stepping motor to drive the probe at controlled velocities down the center of an enclosed channel is described. A typical calibration curve (over the range 0.02-1 m/s) displays the usual characteristics of

A simple method for measuring the low te
A simple method for measuring the low temperature thermal conductivity in thin wires
✍ G. Ventura; A. Bonetti; E. Gottardi; L. Lanzi; I. Peroni; A. Peruzzi; G. Ponti 📂 Article 📅 1998 🏛 Elsevier Science 🌐 English ⚖ 104 KB

A new method is presented for measuring the low-temperature thermal conductivity of thin electrically-conducting samples. The proposed two-probe technique is useful mainly in the case of non free-standing samples of medium and high thermal resistivity. The method is simple: a resistance bridge is us