𝔖 Bobbio Scriptorium
✦   LIBER   ✦

A new version of differential flow heat capacity calorimeter; tests of heat loss corrections and heat capacities of aqueous NaCl from T =  300 K to T =  623 K

✍ Scribed by Lubomı́r Hnědkovský; Vladimı́r Hynek; Vladimı́r Majer; Robert H Wood


Publisher
Elsevier Science
Year
2002
Tongue
English
Weight
250 KB
Volume
34
Category
Article
ISSN
0021-9614

No coin nor oath required. For personal study only.

✦ Synopsis


A new differential flow heat capacity calorimeter was constructed. It is designed to operate at temperatures up to 700 K and pressures up to 35 MPa and its primary use is for determining the massic heat capacities at constant pressure of dilute aqueous solutions. The instrument works in the so-called isoperibol regime, where the fluid sample flowing through the cell is heated by an electrical heater and the power necessary to provide a constant temperature rise is measured relative to that for a reference fluid (water). From the two values of power for sample and water the ratio of massic heat capacities of the sample to that of water can be calculated. A thorough investigation of calibration techniques showed that the calorimetric performance is very sensitive to the thermal conductivities of the sample and reference fluids. Measurements under turbulent flow conditions are questionable since there is no guarantee that by changing the flow rate the experiments and the calibrations would be performed at the same flow conditions. The procedure is very accurate and sensitive when measuring the difference in heat capacity between a solvent and a dilute solution of solute in the same solvent. The calorimeter was used to measure heat capacities of aqueous solutions of NaCl at eight temperatures up to 623 K and pressures to 30 MPa. The newly obtained values show consistency with previously published results and enlarge the database of experimental values above T = 573 K, where experimental data are rare.


📜 SIMILAR VOLUMES


Calorimetric investigation of excess mol
✍ Zhaodong Nan; Beiping Liu; Zhicheng Tan 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 204 KB

The molar excess heat capacity C E p,m of (1 -x)H 2 O + xHOCH 2 CH 2 OH has been measured in the temperature range from 273.15 K to 373.15 K at 5 K intervals. The C E p,m values are negative and positive at all compositions between temperatures of (273.15, 283.15, 333.15 and 373.15) K, respectively.

Heat capacities and entropies of La2O2CO
✍ A. Olafsen; H. Fjellvåg; S. Sølen; T. Atake; H. Kawaji; K. Matsuo 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 213 KB

The heat capacities of La 2 O 2 CO 3 and Nd 2 O 2 CO 3 were determined by adiabatic shield calorimetry from T = (12 to 300) K and T = (12 to 930) K, respectively. For the dineodymium dioxide carbonate a Schottky-type heat capacity with maximum near T = 60 K was observed. The transition is due to spl

Apparent and partial molar heat capaciti
✍ Andrew W. Hakin; Gavin R. Hedwig 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 213 KB

Relative densities and massic heat capacities have been determined for the amino acids L-lysine monohydrochloride and L-arginine monohydrochloride in aqueous solution at the temperatures T = (288. 15, 298.15, 313.15, and 328.15) K. These data have been used to calculate apparent molar properties whi

Partial molar heat capacities and volume
✍ P.K. Banipal; ; T.S. Banipal; b; J.C. Ahluwalia; B.S. Lark 📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 278 KB

Apparent molar heat capacities φC p and volumes φV of seven monosaccharides {D(-)ribose, D(-)-arabinose, D(+)-xylose, D(+)-glucose, D(+)-mannose, D(+)-galactose, D(-)-fructose}, seven disaccharides {sucrose, D(+)-cellobiose, lactulose, D(+)-melibiose hemihydrate, D(+)-maltose monohydrate, D(+)-lacto