✦ LIBER ✦

A comparison between four elasto-plastic fracture mechanics parameters

✍ Scribed by J.D. Harrison

Publisher: Elsevier Science
Year: 1977
Tongue: English
Weight: 474 KB
Volume: 5
Category: Article
ISSN: 0308-0161
DOI: 10.1016/0308-0161(77)90007-2

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A numerical study of two integral type e

A numerical study of two integral type elasto-plastic fracture parameters under cyclic loading

✍ A.K. Wong; R. Jones 📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 815 KB

## This paper examines the behaviour of two elasto-plastic fracture parameters which characterise the severity of a crack-tip field under large scale yielding. One may be regarded as a local crack-tip parameter which associates closely to the stress/strain fields at the crack-tip whilst the other

A note on some crack tip elements employ

A note on some crack tip elements employed in two-dimensional elasto-plastic fracture mechanics

✍ F.M. Furgiuele; M.L. Luchi 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 502 KB

A comparison is drawn between some of the elements most widely employed to model the tip region in elasto-plastic fracture mechanics: i.e. standard 6-node elements, 6-node quarterpoint elements, 8-node collapsed elements, I-node quarter-point collapsed elements. The discussion is particularly focuse

Application of conformal mapping for mes

Application of conformal mapping for mesh generation in two-dimensional elasto-plastic fracture mechanics problems

✍ O. Haber; H. Grebner; A. Höfler 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 681 KB

Conformal mapping techniques may be used for the automatic generation of finite element meshes in two-dimensional fracture mechanics calculations. Using a SchwartzChristoffel conformal transformation, the conformal mapping leads to an optimum mesh in the crack region. This resultant mesh is refined

Fracture mechanics parameters for polyst

Fracture mechanics parameters for polystyrene under high speed impact

✍ D. G. Cook; A. Rudin; A. Plumtree 📂 Article 📅 1990 🏛 Society for Plastic Engineers 🌐 English ⚖ 735 KB

## Abstract A series of commercial polystyrenes was tested using an instrumented impact tester to determine the fracture toughness __K__~__c__~ and critical strain energy release rate __G__~__c__~. Over the range of __M__~__w__~, 201,000 to 336,000, __K__~__c__~ increased from 1.38 MN/m^3/2^ to 1.7

The relationship between load factors an

The relationship between load factors and failure probabilities determined from a full elastic-plastic probabilistic fracture mechanics analysis

✍ R.S. Gates 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 510 KB

Evaluation of plastic eta factors in wel

Evaluation of plastic eta factors in weld metal fracture specimens: A comparison between limit load and common format solutions

✍ J. Donoso; F. Labbé; C. Mora 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 571 KB

Abatrati-The values of the plastic eta factor (q,,,) for deeply cracked compact fracture specimens of ASTM AS88 steel, base metal and weld metal were experimentally determined by using limit load solutions and the property of load separation of the corresponding calibration function for the C(T) spe