16 Fuel science and technology (fundamental science, analysis, instrumentation) benzene adsorption and mercury porosimetry, the porous structure was characterized. Balance calculations expressing quantitative differences in the properties within the granules proved their high ununiformity caused by
98/00281 Fischer-Tropsch synthesis catalysis
- Publisher
- Elsevier Science
- Year
- 1998
- Weight
- 201 KB
- Volume
- 39
- Category
- Article
- ISSN
- 0140-6701
No coin nor oath required. For personal study only.
✦ Synopsis
Gaseous fuels (derived gaseous fuels) 98iOO269
Catalysis of limestone in steam coal gasification Feng, J. et al. Taiyuan Gongye Dame Xuebao, 1996,27, (4), 50-56, 60. (In Chinese) DTA in combination with GC was used to study the coal gasification in steam in the presence of JYS, XZS, DSS, and SNS limestone. The results showed that limestones have a function of catalysis on coal gasification, and JYS limestone showed the best results. No definite correlation, however, was found between the Ca/S ratio and the extent of catalysis. Soaking limestone with aqueous NaCl or NazCO, solution before using promoted the catalysis.
98/00270
A cleaner technology for production of LPG + AIR for use as city gas source Han, G. and Shi, Z. Shonghui Huanjing Kexue, 1997, 16, (2), 22-23. (In Chinese) Technology for producing a LPG-air mixed gas for use as city gas was used to replace the conventional method of horizontal furnace for coal gas production.
This was beneficial to alleviating urban air pollution. The emission of SOz, NO,, and COD Mn and the contents of NHs-N, oil, and CN-in the surface water were used as criteria for assessment for the new technology.
📜 SIMILAR VOLUMES
Material published in Focus on Catalysts includes abstracts sourced from Chemical Business NewsBase (CBNB)
The ultimate goal of this work is to gain knowledge of the conditions necessary for sufficient removal of tars from gasification gas. A tar-rich gas is produced through pyrolysis at 700°C and alter steam addition, the produced gas is cracked thermally and catalytically between 700 and 900°C using sh