into which oxygen-containing gasification agents and optionally recycled solids are fed. The height of the conical section is greater by a factor of I-h than the diameter of the cylindrical section. In the fluidized bed, a uniform radial gas flow profile is generated in every horizontal cross-sectio
97/00126 Preparation of carbon sorbent from coal
- Publisher
- Elsevier Science
- Year
- 1997
- Weight
- 169 KB
- Volume
- 38
- Category
- Article
- ISSN
- 0140-6701
No coin nor oath required. For personal study only.
β¦ Synopsis
0 1 Solid fuels (derived solid fuels) 97/00111 Criteria for selection of coal fuels for the cement industry Jaron-Kocot. M., hze@. Gorn. 1996, 52, (5). 24-28. (In Polish) Presents the criteria for the coal fuel selection for the cement industry. Coal meets the requirements of ecological and economic profitability. Quality requirements for fuels used for clinker production are analysed. Examples of the calculations of technological parameters for three coal grades in three selected cement plants are cited.
π SIMILAR VOLUMES
By-products related to fuels sand in 3:l and 2:1 ratios for lettuce was similar to peat substrate alone, while the yield of tomato was higher if the 3:l ratio was used. 10% addition of brown coal ash had an advantageous effect on the yields of both of the tested vegetables. 97lQQ377 Fireside slaggi
Significance of puff temperature method in spontaneous heating of coals
The batteries discussed are lithium batteries. The preparation of the anodes, which are composed of highly conductive carbonaceous material grains coated with a glassy or graphitized carbon layer, comprises applying a precursor of the carbon layer to a powdered carbonaceous material and sintering at
04 By-products related to fuels ## 97102816 New knowledge about effects of bituminous coal fly ash in concrete Haerdtl, R. ef al. VGB