9. Volume changes in phenolic resin during carbonization
โ Scribed by R.A. Jones; G.M. Jenkins
- Publisher
- Elsevier Science
- Year
- 1976
- Tongue
- English
- Weight
- 158 KB
- Volume
- 14
- Category
- Article
- ISSN
- 0008-6223
No coin nor oath required. For personal study only.
โฆ Synopsis
Carbon deposits are generally formed during the steamcracking of hydrocarbons. According to the hydrocarbon used, the carbonaceous material can be formed as follows: the initial hydrocarbon reacts in the gas phase: in the case of n hexane, gaseous reactants decompose on the wall of the reactors. The carbonaceous film is smooth and shiny; in the case of cyclohexane and toluene, the gas phase reactions induce the formation of high molecular hydrocarbons which condense in microdroplets which strike the substrat. The microdroplets spread or do not spread, depending on the type of solid sub&rat.
๐ SIMILAR VOLUMES
Mixtures of a benzene-soluble part in pitch (BS-pitch) and a phenol resin powder were carbonized under pressure, and the textures of the resultant carbons were characterized by polarizedlight microscopy. Under the pressure of 30 MPa, the carbon with a homogeneous texture was obtained; the size of mo
The pyrolysis of carbon/phenolic composites is a critical step in the manufacture of high temperature carbon/carbon components. Understanding the reaction kinetics of the pyrolysis reactions is essential for advancement in the processing of carbon/carbon materials. To increase the understanding of t
## On pyrolysis of a phenol-formaldehyde resin at temperatures up to 700ยฐC there was no change in the infra-red spectrum below 300ยฐC but above this temperature the hydroxyl absorption began to decrease. This and other changes indicated the formation of diphenyl ether type linkages between benxene
Small-Angle X-ray Scattering (SAXS) has been used as an analytical tool to study the development of microstructure with increasing Heat Treatment Temperature (HTT) of a carbonized phenolic resin, which is often used as matrix in commercial carbon-carbon composites. Processing parametersheating rate
The inorganic constituents of low-rank Victorian brown coal, which are mainly present as inherent inorganic combinations attached to the coal molecule, are different from the minerals present in higher-rank coals. Changes in the state of combination of the inorganics in the chars of these coals have