✦ LIBER ✦

66. Investigation of the volume effect on mechanical properties of various industrial graphites

✍ Scribed by F Lanza; H Burg

Publisher: Elsevier Science
Year: 1973
Tongue: English
Weight: 137 KB
Volume: 11
Category: Article
ISSN: 0008-6223
DOI: 10.1016/0008-6223(73)90402-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Effect of spherulites on the mechanical

Effect of spherulites on the mechanical properties of nylon 66

✍ Howard W. Starkweather Jr.; Richard E. Brooks 📂 Article 📅 1959 🏛 John Wiley and Sons 🌐 English ⚖ 342 KB 👁 2 views

## Abstract The presence of spherulites in nylon 66 increases the yield point and reduces the effects of variations in per cent crystallinity. Decreasing the size of the spherulites through increased nucleation results in a higher flexural modulus and yield point, a lower ultimate elongation, and a

300. Irradiation effects on the mechanic

300. Irradiation effects on the mechanical properties of graphites for HTGRS

✍ T. Oku; M. Eto; K. Fujisaki 📂 Article 📅 1982 🏛 Elsevier Science 🌐 English ⚖ 121 KB

Abstracts damage flux levels differing by a factor of about 8. Dimensional changes and thermal resistivity changes at the same irradiation temperatures at both flux levels are intercompared up to fast neutron doses -lO"n/cm\* (DNE). 299. The effect of fast neutron irradiation on the stressshin relat

The effect of hydrolytic and thermal deg

The effect of hydrolytic and thermal degradation on mechanical properties of industrial polyester yarns

✍ M. Sheikhzadeh; I. Ghaeli; E. Pirzadeh; F. Bateni 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 145 KB 👁 2 views

## Abstract For industrial polyester yarns, the study of hydrolytic/thermal degradation is important, because of the negative influence of these degradations on mechanical properties of polyester yarns. In this research, tensile force at breaking point and elongation at break were used to assess th

The effect of Graphitization on the Mech

The effect of Graphitization on the Mechanical Properties of twodimensional carbon – carbon composites

✍ Dr. A. Sedghi; Prof. Dr. F. Golestani Fard 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 534 KB

## Abstract In this article the effect of graphitization in twodimensional c‐c composite bodies prepared by impregnation of novalak resin is reported. Mechanical properties were determined by bending tests and microstructural features were studied by SEM and XRD. It was found that primary graphitiz

Dynamic mechanical properties of nylon 6

Dynamic mechanical properties of nylon 66 and the plasticizing effect of water vapor on nylon. II

✍ J. M. R. Quistwater; B. A. Dunell 📂 Article 📅 1959 🏛 John Wiley and Sons 🌐 English ⚖ 464 KB 👁 2 views

## Abstract The dynamic tensile modulus and energy loss have been measured for nylon 66 monofilaments at 9 and 60°C. over a wide humidity range in forced longitudinal vibration experiments. The frequency range covered was about 3 to 30 cycles/sec. (radian frequency 20 to 200 sec.^−1^). The results

Effect of thermal-oxidative aging on mec

Effect of thermal-oxidative aging on mechanical, chemical, and thermal properties of recycled polyamide 66

✍ P.-A. Eriksson; P. Boydell; K. Eriksson; J.-A. E. Månson; A.-C. Albertsson 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 235 KB 👁 2 views

This article addresses the effect of thermal aging on unreinforced and glassreinforced recycled polyamide 66. As an accelerated test, injection-molded test bars were aged at 110, 140, and 170ЊC for up to 4000 h in air to simulate service life. FTIR spectroscopy demonstrated that the oxidative degrad