✦ LIBER ✦

X-ray diffraction and magnetic characterization of the retained austenite in a chromium alloyed high carbon steel

✍ Scribed by S. S. M. Tavares; S. R. Mello; A. M. Gomes; J. M. Neto; M. R. da Silva; J. M. Pardal

Book ID: 106391276
Publisher: Springer
Year: 2006
Tongue: English
Weight: 561 KB
Volume: 41
Category: Article
ISSN: 0022-2461
DOI: 10.1007/s10853-006-0025-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A study of the retained austenite phase

A study of the retained austenite phase transformation in low alloy steel using conversion electron Mössbauer spectroscopy and X-ray diffraction

✍ S. Skrzypek; E. Kolawa; J.A. Sawicki; T. Tyliszczak 📂 Article 📅 1984 🏛 Elsevier Science ⚖ 346 KB

In situ characterizations of phase trans

In situ characterizations of phase transformations kinetics in the Ti17 titanium alloy by electrical resistivity and high temperature synchrotron X-ray diffraction

✍ Fabien Bruneseaux; Elisabeth Aeby-Gautier; Guillaume Geandier; Julien Da Costa T 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 671 KB

Characterization by glancing angle X-ray

Characterization by glancing angle X-ray diffraction of the interface between austenitic stainless steel AISI 304 substrates and a TiN or Ti/TiN physical vapour deposition coating

✍ C. Quaeyhaegens; L.M. Stals; L. De Schepper; M. Van Stappen; B. Malliet 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 876 KB

A dilatometric and high-temperature X-ra

A dilatometric and high-temperature X-ray diffraction study of cold deformation effect on the interaction between precipitation, recovery and recrystallization reactions in Al–12 wt.% Mg alloy

✍ A. Hayoune; D. Hamana 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 576 KB

Influence of the mode of introduction of

Influence of the mode of introduction of a reactive element on the high temperature oxidation behavior of an alumina-forming alloy. Part III: The use of two stage oxidation experiments and in situ X-ray diffraction to understand the oxidation mechanisms

✍ S. Chevalier; C. Issartel; R. Cueff; H. Buscaif; G. Strehl; G. Borchardt 📂 Article 📅 2006 🏛 John Wiley and Sons 🌐 German ⚖ 476 KB

The aim of this work was to investigate several different yttrium introduction routes to improve the high temperature oxidation resistance of a Fe-20Cr-5Al model alloy. Y 2 O 3 sol-gel coatings, Y 2 O 3 metal-organic chemical vapor deposition (MOCVD) coatings, yttrium ion implantation and yttrium as