Workshop Processes and Materials I

✍ Scribed by P. J. Avard, J. Cross (auth.)

• Publisher: Macmillan Education UK
• Year: 1977
• Tongue: English
• Leaves: 112
• Series: Macmillan Technician Series
• Category: Library

✦ Table of Contents

Front Matter....Pages i-vii
Front Matter....Pages 1-1
Introduction....Pages 2-2
Safety at Work....Pages 3-9
Materials....Pages 10-20
Front Matter....Pages 21-21
Introduction to Process Notes....Pages 22-22
Centre lathe, turning between centres. (Figure 1.1)....Pages 23-26
Centre lathe turning, four jaw chuck....Pages 27-30
Taper turning (compound slide)....Pages 31-34
Screw cutting (single-point tool)....Pages 35-38
Turning eccentrics. (Figure 5.1)....Pages 39-42
Centre lathe, taper-turning attachment....Pages 43-46
Centre lathe, face plate....Pages 47-50
Shaping a vee-groove....Pages 51-55
Shaping....Pages 57-60
Marking-out, hand sawıng and filing....Pages 61-65
Marking-out....Pages 67-70
Spacing holes on a pitch circle....Pages 71-74
Marking-out, drilling and reaming....Pages 75-79
Marking-out, heat treatment, drilling and bending....Pages 81-85
Accurate hole spacing....Pages 87-91
Soft soldering....Pages 93-97
Front Matter....Pages 21-21
Milling—producing a concentric square on a round bar. (Figure 17.1)....Pages 99-102
Milling—angular indexing....Pages 103-107
Milling a four-jaw coupling (or jaw clutch). (Figure 19.1)....Pages 109-112

✦ Subjects

Industrial and Production Engineering