✦ LIBER ✦

Working of thick sheet metal by pressure

✍ Scribed by Yu. V. Shukhov

Publisher: Springer
Year: 1968
Tongue: English
Weight: 111 KB
Volume: 4
Category: Article
ISSN: 0009-2355
DOI: 10.1007/bf01139385

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Surface hardening of parts of metal powd

Surface hardening of parts of metal powders by working by pressure (review)

✍ G. G. Serdyuk 📂 Article 📅 1993 🏛 Springer 🌐 English ⚖ 758 KB

Laser-Assisted Sheet Metal Working of Hi

Laser-Assisted Sheet Metal Working of High Strength Steels in Serial Production

✍ Christian Brecher; Michael Emonts; Markus Eckert 📂 Article 📅 2011 🏛 Elsevier 🌐 English ⚖ 1013 KB

Experimental and numerical (FEM) analysi

Experimental and numerical (FEM) analysis of deep drawing of relatively thick sheet metal

✍ Z. Kampuš; K. Kuzman 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 432 KB

The paper deals with an analysis of deep drawing without blankholder with special emphasis on workpiece geometry. The process was simulated by the FEM using a rigid--plastic model. Because of a relatively small forming speed (a hydraulic press is normally used) and small deformations, temperature wa

Model-assisted investigation of abutment

Model-assisted investigation of abutment pressure in the working of thick steep seams

✍ G. I. Gritsko; V. A. Shalaurov; V. N. Kulakov 📂 Article 📅 1965 🏛 Springer 🌐 English ⚖ 209 KB

Reducing rock pressure effects during wo

Reducing rock pressure effects during working of thick steeply dipping seams with stowing

✍ N. I. Yakovlev; R. P. Bolotov; G. I. Chuntu 📂 Article 📅 1971 🏛 Springer 🌐 English ⚖ 280 KB

Flattening of sheet metal by laser formi

Flattening of sheet metal by laser forming

✍ Takashi Ueda; Eisuke Sentoku; Yoshihiro Wakimura; Akira Hosokawa 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 838 KB