𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Warpage phenomenon of thin-wall injection molding

✍ Scribed by Yuh-Chyun Chiang; Hsin-Chung Cheng; Chiung-Fang Huang; Jeou-Long Lee; Yi Lin; Yung-Kang Shen

Book ID
105854140
Publisher
Springer
Year
2010
Tongue
English
Weight
992 KB
Volume
55
Category
Article
ISSN
0268-3768

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Investigation of mold plate separation i
Investigation of mold plate separation in thin-wall injection molding
✍ Shia-Chung Chen; Wei-Liang Liaw; Pao-Lin Su; Ming-Hsiu Chung πŸ“‚ Article πŸ“… 2003 πŸ› John Wiley and Sons 🌐 English βš– 577 KB

## Abstract Precision injection molding of thin‐wall parts has become an important concern in 3C (computer, communication, and consumer electronics) plastics industry. Previous studies in precision injection molding control focused on the injection screw, the hydraulic system control and the associ

Integrated simulation to predict warpage
Integrated simulation to predict warpage of injection molded parts
✍ Takaaki Matsuoka; Jun-Ichi Takabatake; Akihiko Koiwai; Yoshinori Inoue; Satoru Y πŸ“‚ Article πŸ“… 1991 πŸ› Society for Plastic Engineers 🌐 English βš– 666 KB

## Abstract Injection molding analysis programs were developed for CAE (Computer Aided Engineering) in injection molding of thermoplastics. The programs consist of mold cooling, polymer filling‐packing‐cooling, fiber orientation, material properties and stress analyses. These programs are integrate

Injection molding and injection compress
Injection molding and injection compression molding of thin-walled light-guided plates with V-grooved microfeatures
✍ Ming-Shyan Huang; Chin-Feng Chung πŸ“‚ Article πŸ“… 2011 πŸ› John Wiley and Sons 🌐 English βš– 550 KB

## Abstract In this study, we investigated the feasibility of injection molding (IM) and injection compression molding (ICM) for fabricating 3.5‐in. light‐guided plates (LGPs). The LGP was 0.4 mm thick with v‐grooved microfeatures (10 ΞΌm wide and 5 ΞΌm deep). A mold was designed to fabricate LGPs by

Analysis for optimal gate design of thin
Analysis for optimal gate design of thin-walled injection molding
✍ Yung-Kang Shen; Chih-Wei Wu; Ya-Feng Yu; Hung-Wei Chung πŸ“‚ Article πŸ“… 2008 πŸ› Elsevier Science 🌐 English βš– 716 KB

The 3C (Computer, Communication and Consumer) product has the properties of being light, thin, short and small. In this study, numerical simulations of three-dimensional injection molding are used for thin-walled product. The governing differential equations are discredited by using control volume f