Unsaturated polyester prepolymer from rosin
β Scribed by Le Thi Nhut Hoa; J.P. Pascault; Lam Thanh My; Chu Pham Ngoc Son
- Publisher
- Elsevier Science
- Year
- 1993
- Tongue
- English
- Weight
- 287 KB
- Volume
- 29
- Category
- Article
- ISSN
- 0014-3057
No coin nor oath required. For personal study only.
β¦ Synopsis
Unsaturated polyester prepolymer was synthesized from maleopimaric acid (MPA), diethylene glycol (DEG) and maleic anhydride (MA) in the molar proportions 1 : 4:3 respectively. MPA was prepared from natural rosin and MA. Kinetic studies of the reaction were performed, and the reactivities of MPA, MA and phthalic anhydride (PA) with respect to diethylene glycol were compared. Copolymerized with styrene, this prepolymer gave samples with higher Vicat distortion temperatures than usual commercial samples prepared from PA, MA and propylene glycol, while mechanical properties such as modulus and strength were similar.
π SIMILAR VOLUMES
Based on the structural model being derived in Part I, a statistics approach has been used to further estimate separately carboxyl and hydroxyl functionalities of unsaturated polyester (UP) prepolymers directly from their molecular parameters. This extended model shows satisfactory results when comp
A review on the synthesis of unsaturated polyester (UP) prepolymers showed that Ordelt saturation (reaction of hydroxyl groups with double bonds) is the major effect that may cause formation of chain branches and then result in an uncertainty of chain end number or functionality. A model has been de
The effects of temperatures, styrene concentration, and molecular composition of unsaturated polyester (UP) prepolymers on the viscosity of UP-styrene systems are studied. The viscosity of U P resins follows the Arrhenius-type expression with resin temperature as well as with the styrene molar fract
Wood is an inexpensive filler that reduces the overall cost of polymer composites, with loss in some properties (e.g., ultimate strength, elongation, and water sorption often suffer with the addition of fillers) and a gain in others (e.g., Young modulus increment, reduced weight with respect to inor