✦ LIBER ✦

Ultrasonic finish turning of machine rolls

✍ Scribed by L. I. Bondarenko; V. T. Soziev

Publisher: Springer
Year: 1987
Tongue: English
Weight: 573 KB
Volume: 23
Category: Article
ISSN: 0009-2355
DOI: 10.1007/bf01150001

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

High-precision finish machining of large

High-precision finish machining of large smooth rolls

✍ Yu. V. Maksimov; G. M. Azarevich; R. V. Loginov 📂 Article 📅 1999 🏛 Springer 🌐 English ⚖ 471 KB

Determination of the turn interval of a

Determination of the turn interval of a fibre on a finishing roll

✍ G. A. Danilin; V. A. Kalitin; A. T. Serkov; V. G. Zhuravskii; I. N. Krutova 📂 Article 📅 1982 🏛 Springer US 🌐 English ⚖ 302 KB

Turning the rolls of shape mills

✍ M. M. Gelerman; N. P. Borodii 📂 Article 📅 1976 🏛 Springer US 🌐 English ⚖ 133 KB

Device for strengthening-finishing rolli

Device for strengthening-finishing rolling of rolls

✍ R. O. Olzhabaev; V. M. Eidel'man; A. V. Li 📂 Article 📅 1986 🏛 Springer US 🌐 English ⚖ 275 KB

Rolling contact fatigue life of finish h

Rolling contact fatigue life of finish hard machined surfaces: Part 1. Model development

✍ Youngsik Choi; C. Richard Liu 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 495 KB

This research presents a methodology for modeling the rolling contact fatigue life of finish hard machined surfaces. Part 1 of two companion papers presents the development of a life model; Part 2 presents an experimental verification of the life model. A crack initiation life model and a crack prop

Rolling contact fatigue life of finish h

Rolling contact fatigue life of finish hard machined surfaces: Part 2. Experimental verification

✍ Youngsik Choi; C. Richard Liu 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 486 KB

A rolling contact fatigue life model encompassing crack initiation life and crack propagation life was developed in Part 1 of two companion papers. This paper concerns the experimental verification of the developed life model. The specimens were machined by using various machining conditions and at