๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Two-phase cooling of light emitting diode for higher light output and increased efficiency

โœ Scribed by Ye, H.; Mihailovic, M.; Wong, C.K.Y.; van Zeijl, H.W.; Gielen, A.W.J.; Zhang, G.Q.; Sarro, P.M.

Book ID
120982820
Publisher
Elsevier Science
Year
2013
Tongue
English
Weight
1020 KB
Volume
52
Category
Article
ISSN
1359-4311

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Increased Efficiency and Controlled Ligh
Increased Efficiency and Controlled Light Output from a Microstructured Light-Emitting Diode
โœ B. J. Matterson; J. M. Lupton; A. F. Safonov; M. G. Salt; W. L. Barnes; I. D. W. ๐Ÿ“‚ Article ๐Ÿ“… 2001 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 207 KB ๐Ÿ‘ 1 views

SEM images of the APC were obtained as follows: the APC composite membrane was immersed in 6 N NaOH to dissolve the alumina membrane. The template was sputtered to form a thin film of gold on the silver film side and imaged with a Hitachi X650/EDAX, PV9100 scanning electron microanalyzer. XRD of AP

Nanostructuring of an AlGaInP light emit
Nanostructuring of an AlGaInP light emitting diode for surface plasmon enhanced emission of light output
โœ Perks, R. M. ;Kettle, J. ;Lalev, G. M. ;Dimov, S. ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 317 KB

## Abstract This work describes a successful post fabrication method of applying a plasmonic grating to the surface of a mounted AlGaInP LED device. A Carl Zeiss 1540 XB Focused Ion beam system was used to mill holes in a thin gold layer with a periodicity of around 540 nm. Measurements of the tota