✦ LIBER ✦

Tool Selection for Machining of Free Form Surfaces

✍ Scribed by Ersoyoğlu, Ali Serhat; Ünüvar, Ali

Book ID: 126503453
Publisher: Trans Tech Publications Inc.
Year: 2013
Tongue: English
Weight: 269 KB
Volume: 390
Category: Article
ISSN: 1660-9336
DOI: 10.4028/www.scientific.net/AMM.390.581

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Tool path generation for ultra-precision

Tool path generation for ultra-precision machining of free-form surfaces

✍ E. Brinksmeier; O. Riemer; J. Osmer 📂 Article 📅 2008 🏛 Springer-Verlag 🌐 English ⚖ 388 KB

Automated tool sequence selection for 3-

Automated tool sequence selection for 3-axis machining of free-form pockets

✍ Roshan M. D'Souza; Carlo Sequin; Paul K. Wright 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 492 KB

This paper describes an efficient method to find the lowest cost tool sequence for rough machining free-form pockets on a 3-axis milling machine. The free-form pocket is approximated to within a predefined tolerance of the desired surface using series of 2.5-D layers of varying thicknesses that can

NC machining of free form surfaces

✍ Gregory C Loney; Tulga M Ozsoy 📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 855 KB

Tool orientation planning for five-axis

Tool orientation planning for five-axis CNC machining of open free-form surfaces

✍ Zhao, Jibin; Zhong, Bo; Zou, Qiang; Liu, Hongjun 📂 Article 📅 2013 🏛 Academy of Mathematics and Systems Science, Chines 🌐 English ⚖ 482 KB

NC machining of free-form Kriging surfac

NC machining of free-form Kriging surfaces

✍ Abbas Vafaeesefat 📂 Article 📅 2010 🏛 Korean Society for Precision Engineering 🌐 English ⚖ 585 KB

The implementation of adaptive isoplanar

The implementation of adaptive isoplanar tool path generation for the machining of free-form surfaces

✍ S. Ding; M.A. Mannan; A.N. Poo; D.C.H. Yang; Z. Han 📂 Article 📅 2005 🏛 Springer 🌐 English ⚖ 839 KB