✦ LIBER ✦

Tool for machining parts with interrupted surfaces

✍ Scribed by L. B. Stupina; V. A. Zaloga; V. N. Petrenko; S. L. Glushchenko

Publisher: Springer
Year: 1984
Tongue: English
Weight: 121 KB
Volume: 20
Category: Article
ISSN: 0009-2355
DOI: 10.1007/bf01246701

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

High efficiency cutting tool for machini

High efficiency cutting tool for machining stainless steel parts

✍ B. F. Tupikin 📂 Article 📅 1966 🏛 Springer 🌐 English ⚖ 34 KB

Tool path generation for machining compo

Tool path generation for machining compound surfaces with extended cut region method

✍ Jian-Zhong Yang; Qi-Fu Wang; Zheng-Dong Huang; Li-Ping Chen 📂 Article 📅 2006 🏛 Springer 🌐 English ⚖ 459 KB

Machining of hardened steel parts with G

Machining of hardened steel parts with Geksanit tools

✍ A. D. Dzhafarov; R. M. Éfendiev; R. R. Zeinalov 📂 Article 📅 1981 🏛 Springer 🌐 English ⚖ 225 KB

Tool-path generation for machining sculp

Tool-path generation for machining sculptured surface

✍ F. Li; X.C. Wang; S.K. Ghosh; D.Z. Kong; T.Q. Lai; X.T. Wu 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 317 KB

Determining feasible tool-approach direc

Determining feasible tool-approach directions for machining Bézier curves and surfaces

✍ Yuan-Jye Tseng; Sanjay Joshi 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 899 KB

Improvement of machining conditions for

Improvement of machining conditions for slender parts by tuned dynamic stiffness of tool

✍ Eugene I. Rivin; Hongling Kang 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 815 KB

Chatter develops easily when turning slender parts on a lathe because of low stiffness and damping of the system. Also, due to a great variation of the stiffness along the workpiece, the machining accuracy is usually very poor. An analysis of the system characteristics is given and a two degrees of