✦ LIBER ✦

Threshold stresses in high temperature deformation of dispersion strengthened aluminum alloys

✍ Scribed by Fernando Carreño; Oscar A. Ruano

Publisher: Elsevier Science
Year: 1996
Tongue: English
Weight: 275 KB
Volume: 214
Category: Article
ISSN: 0921-5093
DOI: 10.1016/0921-5093(96)10406-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

High-temperature deformation of dispersi

High-temperature deformation of dispersion-strengthened Cu–Zr–Ti–C alloys

✍ Rodrigo H. Palma; Aquiles Sepúlveda; Rodrigo Espinoza; M. Jesús Diánez; José M. 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 174 KB

Inelastic deformation of an aluminum all

Inelastic deformation of an aluminum alloy under combined stress at elevated temperature

✍ G.M. Brown 📂 Article 📅 1970 🏛 Elsevier Science 🌐 English ⚖ 868 KB

High Temperature Tensile Deformation Beh

High Temperature Tensile Deformation Behavior of New Heat Resistant Aluminum Alloy

✍ Sung-Hwan Choi; Si-Young Sung; Hyun-Joo Choi; Young-Ho Sohn; Bum-Suck Han; Kee-A 📂 Article 📅 2011 🏛 Elsevier 🌐 English ⚖ 602 KB

The effect of stress state on high-tempe

The effect of stress state on high-temperature deformation of fine-grained aluminum–magnesium alloy AA5083 sheet

✍ Eric M. Taleff; Louis G. Hector Jr.; John R. Bradley; Ravi Verma; Paul E. Krajew 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 554 KB

The effect of stress state on high-temperature deformation of fine-grained aluminum-magnesium alloy AA5083 sheet is investigated over a range of temperatures and strain rates for which the grain-boundary-sliding and solute-drag creep mechanisms govern plastic flow. Experimental data from uniaxial te

Microstructure-based multiscale modeling

Microstructure-based multiscale modeling of elevated temperature deformation in aluminum alloys

✍ Paul E. Krajewski; Louis G. Hector Jr.; Ningning Du; Allan F. Bower 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 997 KB

A multiscale model for predicting elevated temperature deformation in Al-Mg alloys is presented. Constitutive models are generated from a theoretical methodology and used to investigate the effects of grain size on formability. Flow data are computed with a polycrystalline, microstructure-based mode

Recovery of work-hardening and low tempe

Recovery of work-hardening and low temperature creep in dispersion strengthened Cu alloys with rod shaped particles

✍ Michio Okabe; T. Mori 📂 Article 📅 1979 🏛 Elsevier Science ⚖ 856 KB

Low temperature recovery of work-hardenmg and creep tn a copper single crystal, dispersion strengthened with rod shaped oxide particles. have been studied. The climb rate of an Orowan loop surroundmg a rod shaped particle has been analysed on the basis of dislocation pipe diffusion. This analysis sa