✦ LIBER ✦

Thermal stability of the Al70Ni10Ti10Zr5Ta5 amorphous alloy powder fabricated by mechanical alloying

✍ Scribed by Xiu Wei; Xinfu Wang; Fusheng Han; Haowen Xie; Cui’e Wen

Book ID: 116606293
Publisher: Elsevier Science
Year: 2010
Tongue: English
Weight: 483 KB
Volume: 496
Category: Article
ISSN: 0925-8388
DOI: 10.1016/j.jallcom.2010.02.003

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Comment on the paper ‘Thermal stability

Comment on the paper ‘Thermal stability of the Al70Ni10Ti10Zr5Ta5 amorphous alloy powder fabricated by mechanical alloying’ by Xiu Wei, Xinfu Wang, Fusheng Han, Haowen Xie, Cui’e Wen, J. Alloys Compd. 496 (2010) 313–316

✍ K.G. Prashanth 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 262 KB

Thermal stability of mechanically alloye

Thermal stability of mechanically alloyed nitride/amorphous Zr65Al7.5Cu17.5Ni10 alloy composites

✍ C.R Zhou; J Xu 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 578 KB

Crystallization kinetics of an amorphous

Crystallization kinetics of an amorphous Al75Ni10Ti10Zr5alloy

✍ Xiu Wei; Xingfu Wang; Xinfu Wang; Fusheng Han 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 368 KB

Crystallization Behavior of Amorphous Zr

Crystallization Behavior of Amorphous Zr55Cu20Ni10Al10Ti5Alloy

✍ Jingfu Wang; Yan Wang 📂 Article 📅 2011 🏛 Springer 🌐 English ⚖ 423 KB

Characterization of Ni57Zr20Ti18Al5 amor

Characterization of Ni57Zr20Ti18Al5 amorphous powder obtained by mechanical alloying

✍ Pee-Yew Lee; Chung-Kwei Lin; I.-Kuan Jeng; Chien-Chung Wang; Giin-Shan Chen 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 194 KB

High-purity amorphous Zr52.5Cu17.9Ni14.6

High-purity amorphous Zr52.5Cu17.9Ni14.6Al10Ti5 powders via mechanical amorphization of crystalline pre-alloys

✍ Marco E. Siegrist; Michael Siegfried; Jörg F. Löffler 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 407 KB

Fully amorphous Zr 52.5 Cu 17.9 Ni 14.6 Al 10 Ti 5 (Vit 105) powder with very low oxygen contamination was successfully produced from pre-alloyed crystalline material. A yield of over 80% was achieved without the use of a milling agent. The amorphization process was observed by differential scanning