✦ LIBER ✦

The use of the model technique in the prediction of the pressure distribution over the tool surfaces in cold forging

✍ Scribed by V. Maegaard

Publisher: Elsevier Science
Year: 1985
Weight: 959 KB
Volume: 12
Category: Article
ISSN: 0378-3804
DOI: 10.1016/0378-3804(85)90134-2

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Comments on the use of the model-materia

Comments on the use of the model-material technique in the hot forging of brass

✍ Bo Anulf; Dick Lindqvist; Curt Lundin 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 544 KB

The validation of the upper-bound elemen

The validation of the upper-bound elemental technique (UBET) in the prediction of strain distributions in forgings

✍ B.O. Oyekanmi; A.N. Bramley; F.H. Osman 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 556 KB

Influence of friction on the prediction

Influence of friction on the prediction of forces, pressure distributions and properties in upset forging

✍ P. Hartley; C.E.N. Sturgess; G.W. Rowe 📂 Article 📅 1980 🏛 Elsevier Science 🌐 English ⚖ 678 KB

An experimental determination of the rol

An experimental determination of the roll pressure distributions in cold rolling

✍ F.A.R. Al-Salehi; T.C. Firbank; P.R. Lancaster 📂 Article 📅 1973 🏛 Elsevier Science 🌐 English ⚖ 878 KB

The use of ac field measurement techniqu

The use of ac field measurement technique in crack profile prediction

✍ M.O. Lai 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 532 KB

Ahatrac-The depths of surface cracks of different pro&s have been estimated using the alternating current field measurement technique. The method made use of an instrument known as Crack MiCroGauge. From the results, it was found that the technique produced reasonably good accuracy for cracks of con

The use of surface analysis techniques i

The use of surface analysis techniques in the study of wear

✍ William A. Glaeser 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 878 KB