𝔖 Bobbio Scriptorium
✦   LIBER   ✦

The surface properties of carbon-I the effect of activated diffusion in the determination of surface area

✍ Scribed by H. Marsh; W.F.K. Wynne-Jones


Publisher
Elsevier Science
Year
1964
Tongue
English
Weight
942 KB
Volume
1
Category
Article
ISSN
0008-6223

No coin nor oath required. For personal study only.

✦ Synopsis


This study forms part of a research programme concerned with structure, reactivity and electron-spin-resonance properties of carbons prepared from eight organic polymers. The possible use of carbon dioxide, on a routine basis, in the determination of surface area of carbons has been investigated. The results show that the rate of diffusion of nitrogen molecules into the carbon at 77Β°K can be markedly low. This is caused by the temperature dependence of the rate of the diffusion. Surface area values, determined from the nitrogen isotherms, are accordingly too low. The rate of adsorption of carbon dioxide at 195Β°K is always very much higher than that of nitrogen and appreciable adsorption of carbon dioxide can occur where no adsorption of nitrogen is detectable. When the carbon structure is equally accessible to nitrogen and carbon dioxide, surface area values calculated from the carbon dioxide and nitrogen isotherms are comparable. The adsorption of carbon dioxide at 273Β°K can be shown to indicate if the adsorption of the carbon dioxide at 195Β°K is itself restricted.


πŸ“œ SIMILAR VOLUMES


The surface properties of carbon-II the
✍ T.G. Lamond; H. Marsh πŸ“‚ Article πŸ“… 1964 πŸ› Elsevier Science 🌐 English βš– 886 KB

With carbons which have a large internal volume, the problem of determining the surface area is extremely difficult because the range of usefulness of the BET and other adsorption equations which predict a monolayer capacity, extends into the pressure range where capillary condensation occurs. Altho

Film-surface diffusion during the adsorp
✍ KKH Choy; JF Porter; G McKay πŸ“‚ Article πŸ“… 2004 πŸ› Wiley (John Wiley & Sons) 🌐 English βš– 150 KB

## Abstract A mass transport model has been developed and applied to the adsorption of three acid dyes onto activated carbon in three single component systems. The mass transfer model is based on two rate controlling mass transfer steps, namely external film mass transfer and homogeneous solid‐phas