✦ LIBER ✦

The structure and rheology of molten ultra-high-molecular-mass polyethylene

✍ Scribed by P. Gao; M.R. Mackley

Publisher: Elsevier Science
Year: 1994
Tongue: English
Weight: 897 KB
Volume: 35
Category: Article
ISSN: 0032-3861
DOI: 10.1016/0032-3861(94)90471-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Effects of molecular structure on the rh

Effects of molecular structure on the rheology and processability of blow-molding high-density polyethylene resins

✍ Alfonsius B. Ariawan; Savvas G. Hatzikiriakos; Shivendra K. Goyal; Henry Hay 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 445 KB 👁 2 views

Influence of molecular structure on the

Influence of molecular structure on the rheology and thermorheology of metallocene polyethylenes

✍ Ibnelwaleed A. Hussein; Tayyab Hameed; Michael C. Williams 📂 Article 📅 2006 🏛 John Wiley and Sons 🌐 English ⚖ 389 KB 👁 2 views

## Abstract The rheology of linear and branched metallocene polyethylenes (m‐PEs) was investigated. The linear metallocenes were prepared by gas‐phase polymerization, while the branched PEs were commercial resins. Molecular parameters such as __M__~__w__~, branch type, and molecular weight distribu

Modeling the oxidative degradation of ul

Modeling the oxidative degradation of ultra-high-molecular-weight polyethylene

✍ Vinay Medhekar; Robert W. Thompson; Aiguo Wang; W. Grant McGimpsey 📂 Article 📅 2002 🏛 John Wiley and Sons 🌐 English ⚖ 171 KB 👁 2 views

Evaluation of sequentially crosslinked u

Evaluation of sequentially crosslinked ultra-high molecular weight polyethylene

✍ M. L. Morrison; S. Jani 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 404 KB

## Abstract This study was undertaken to investigate the effect of crosslinking ultra‐high molecular weight polyethylene (UHMWPE) in a sequential manner to the final desired dose and to compare the results to single‐dose crosslinking. To verify these results, an explanted, commercially available, s

Surface modification of ultra-high-molec

Surface modification of ultra-high-molecular-weight polyethylene. II. Effect on the physicomechanical and tribological properties of ultra-high-molecular-weight polyethylene/poly(ethylene terephthalate) composites

✍ Mostafa Rezaei; Azadeh Shirzad; Nadereh Golshan Ebrahimi; Marianna Kontopoulou 📂 Article 📅 2005 🏛 John Wiley and Sons 🌐 English ⚖ 426 KB 👁 2 views

Morphology and melting behavior of nasce

Morphology and melting behavior of nascent ultra-high molecular weight polyethylene

✍ Roger A. Phillips 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 643 KB

The nascent morphology of UHMW PE exhibits high melting point, high crystallinity, and increased WAXS line breadth relative to samples formed by melt crystallization. Different empirical relationships between crystal size and melting point are observed for nascent and molded samples. This differenti