✦ LIBER ✦

The selection of dynamic acceptance test conditions for machine tools

✍ Scribed by Sadek, M.M.; Knight, W.A.

Book ID: 119751863
Publisher: Institution of Electrical Engineers
Year: 1972
Weight: 1018 KB
Volume: 51
Category: Article
ISSN: 0032-9851
DOI: 10.1049/tpe:19720072

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Dynamic acceptance tests for machine too

Dynamic acceptance tests for machine tools

✍ S.A. Tobias 📂 Article 📅 1962 🏛 Elsevier Science ⚖ 871 KB

Acceptance test charts for machine tools

📂 Article 📅 1940 🏛 Institution of Electrical Engineers ⚖ 103 KB

Workpiece accuracy criterion for the dyn

Workpiece accuracy criterion for the dynamic machine tool acceptance test

✍ J. Peklenik; J.R. Gartner 📂 Article 📅 1967 🏛 Elsevier Science ⚖ 904 KB

A New Method for Circular Testing of Mac

A New Method for Circular Testing of Machine Tools Under Loaded Condition

✍ Andreas Archenti; Mihai Nicolescu; Guillaume Casterman; Sven Hjelm 📂 Article 📅 2012 🏛 Elsevier 🌐 English ⚖ 870 KB

Improvement of machining conditions for

Improvement of machining conditions for slender parts by tuned dynamic stiffness of tool

✍ Eugene I. Rivin; Hongling Kang 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 815 KB

Chatter develops easily when turning slender parts on a lathe because of low stiffness and damping of the system. Also, due to a great variation of the stiffness along the workpiece, the machining accuracy is usually very poor. An analysis of the system characteristics is given and a two degrees of

British standards for testing the accura

British standards for testing the accuracy of machine tools

✍ Agar, C.H. 📂 Article 📅 1973 🏛 Institution of Electrical Engineers ⚖ 170 KB